[PATCH v3 7/7] spi: imx: defer spi initialization, if DMA engine is pending

Sascha Hauer s.hauer at pengutronix.de
Thu Nov 5 00:59:26 PST 2015


On Sun, Nov 01, 2015 at 03:41:41PM +0100, Anton Bondarenko wrote:
> From: Anton Bondarenko <anton_bondarenko at mentor.com>
> 
> If SPI device supports DMA mode, but DMA controller is not yet
> available due to e.g. a delay in the corresponding kernel module
> initialization, retry to initialize SPI driver later on instead of
> falling back into PIO only mode.
> 
> Signed-off-by: Vladimir Zapolskiy <vladimir_zapolskiy at mentor.com>
> Signed-off-by: Anton Bondarenko <anton_bondarenko at mentor.com>

Ok, so 6/7 is only part of the deferral story. Maybe squash the two
patches into one?

Sascha

> ---
>  drivers/spi/spi-imx.c | 12 +++++++++---
>  1 file changed, 9 insertions(+), 3 deletions(-)
> 
> diff --git a/drivers/spi/spi-imx.c b/drivers/spi/spi-imx.c
> index 6035ddd..d2ea731 100644
> --- a/drivers/spi/spi-imx.c
> +++ b/drivers/spi/spi-imx.c
> @@ -1354,9 +1354,15 @@ static int spi_imx_probe(struct platform_device *pdev)
>  	 * Only validated on i.mx6 now, can remove the constrain if validated on
>  	 * other chips.
>  	 */
> -	if (is_imx51_ecspi(spi_imx) &&
> -	    spi_imx_sdma_init(&pdev->dev, spi_imx, master))
> -		dev_err(&pdev->dev, "dma setup error,use pio instead\n");
> +	if (is_imx51_ecspi(spi_imx)) {
> +		ret = spi_imx_sdma_init(&pdev->dev, spi_imx, master);
> +		if (ret == -EPROBE_DEFER)
> +			goto out_clk_put;
> +
> +		if (ret < 0)
> +			dev_err(&pdev->dev, "dma setup error %d, use pio\n",
> +				ret);
> +	}
>  
>  	spi_imx->devtype_data->reset(spi_imx);
>  
> -- 
> 2.6.2
> 
> 

-- 
Pengutronix e.K.                           |                             |
Industrial Linux Solutions                 | http://www.pengutronix.de/  |
Peiner Str. 6-8, 31137 Hildesheim, Germany | Phone: +49-5121-206917-0    |
Amtsgericht Hildesheim, HRA 2686           | Fax:   +49-5121-206917-5555 |



More information about the linux-arm-kernel mailing list