[PATCH 1/2 V2] ls2080a/dts: Add little endian property for GPIO IP block

Liu Gang Gang.Liu at freescale.com
Wed Nov 4 18:42:21 PST 2015


The GPIO block for ls2080a platform has little endian registers,
the GPIO driver needs this property to read/write registers by
right interface.

Signed-off-by: Liu Gang <Gang.Liu at freescale.com>
---
V2 changes: No

 Documentation/devicetree/bindings/gpio/gpio-mpc8xxx.txt | 3 +++
 arch/arm64/boot/dts/freescale/fsl-ls2080a.dtsi          | 4 ++++
 2 files changed, 7 insertions(+)

diff --git a/Documentation/devicetree/bindings/gpio/gpio-mpc8xxx.txt b/Documentation/devicetree/bindings/gpio/gpio-mpc8xxx.txt
index f2455c5..c836dab 100644
--- a/Documentation/devicetree/bindings/gpio/gpio-mpc8xxx.txt
+++ b/Documentation/devicetree/bindings/gpio/gpio-mpc8xxx.txt
@@ -10,6 +10,9 @@ Required properties:
   the second cell is used to specify the gpio polarity:
       0 = active high
       1 = active low
+- little-endian : Should be set if the GPIO has little endian
+		  registers. No the property means the GPIO
+		  registers are big endian mode.
 
 Example:
 
diff --git a/arch/arm64/boot/dts/freescale/fsl-ls2080a.dtsi b/arch/arm64/boot/dts/freescale/fsl-ls2080a.dtsi
index e81cd48..0099205 100644
--- a/arch/arm64/boot/dts/freescale/fsl-ls2080a.dtsi
+++ b/arch/arm64/boot/dts/freescale/fsl-ls2080a.dtsi
@@ -277,6 +277,7 @@
 			reg = <0x0 0x2300000 0x0 0x10000>;
 			interrupts = <0 36 0x4>; /* Level high type */
 			gpio-controller;
+			little-endian;
 			#gpio-cells = <2>;
 			interrupt-controller;
 			#interrupt-cells = <2>;
@@ -287,6 +288,7 @@
 			reg = <0x0 0x2310000 0x0 0x10000>;
 			interrupts = <0 36 0x4>; /* Level high type */
 			gpio-controller;
+			little-endian;
 			#gpio-cells = <2>;
 			interrupt-controller;
 			#interrupt-cells = <2>;
@@ -297,6 +299,7 @@
 			reg = <0x0 0x2320000 0x0 0x10000>;
 			interrupts = <0 37 0x4>; /* Level high type */
 			gpio-controller;
+			little-endian;
 			#gpio-cells = <2>;
 			interrupt-controller;
 			#interrupt-cells = <2>;
@@ -307,6 +310,7 @@
 			reg = <0x0 0x2330000 0x0 0x10000>;
 			interrupts = <0 37 0x4>; /* Level high type */
 			gpio-controller;
+			little-endian;
 			#gpio-cells = <2>;
 			interrupt-controller;
 			#interrupt-cells = <2>;
-- 
2.1.0.27.g96db324




More information about the linux-arm-kernel mailing list