[PATCH V2 2/3] ARM: at91/dt: sama5d4: Add pinmux for 8-bit MMC0 bus
Marek Vasut
marex at denx.de
Wed Nov 4 18:25:32 PST 2015
On Thursday, November 05, 2015 at 03:15:41 AM, Josh Wu wrote:
> Hi, Marek
>
> On 11/5/2015 6:14 AM, Marek Vasut wrote:
> > Add pinmux for the 4 remaining signals used in 8-bit MMC 0
> > bus configuration.
> >
> > Signed-off-by: Marek Vasut <marex at denx.de>
> > Cc: Alexandre Belloni <alexandre.belloni at free-electrons.com>
> > Cc: Josh Wu <josh.wu at atmel.com>
> > Cc: Nicolas Ferre <nicolas.ferre at atmel.com>
> > ---
> >
> > arch/arm/boot/dts/sama5d4.dtsi | 8 ++++++++
> > 1 file changed, 8 insertions(+)
> >
> > V2: Repair the incorrect comments for the pinmux, original version
> >
> > of the commment contained wrong MCI0_DAx references.
> >
> > diff --git a/arch/arm/boot/dts/sama5d4.dtsi
> > b/arch/arm/boot/dts/sama5d4.dtsi index 48ca530..d086a7d 100644
> > --- a/arch/arm/boot/dts/sama5d4.dtsi
> > +++ b/arch/arm/boot/dts/sama5d4.dtsi
> > @@ -1651,6 +1651,14 @@
> >
> > AT91_PIOC 9
AT91_PERIPH_B AT91_PINCTRL_PULL_UP /* MCI0_DA3,
> > conflict with NAND_D4
*/
> >
> > >;
> >
> > };
> >
> > + pinctrl_mmc0_dat4_7: mmc0_dat4_7 {
> > + atmel,pins =
> > + <AT91_PIOC 10
AT91_PERIPH_B AT91_PINCTRL_PULL_UP /* MCI0_DA4,
> > conflict with NAND_D5 */ +
AT91_PIOC 11 AT91_PERIPH_B
> > AT91_PINCTRL_PULL_UP /* MCI0_DA5, conflict with NAND_D6 */ +
> > AT91_PIOC 12 AT91_PERIPH_B AT91_PINCTRL_PULL_UP /* MCI0_DA6, conflict
> > with NAND_D7 */ +
AT91_PIOC 13 AT91_PERIPH_B
> > AT91_PINCTRL_PULL_UP /* MCI0_DA7, conflict with NAND_D8 */
>
> PC13 is conflicted with NRD/NANDOE, not D8 (PB18).
> with this comment fix, you can add:
> Reviewed-by: Josh Wu <josh.wu at atmel.com>
Thanks, patch is out, hope I got it right this time.
Best regards,
Marek Vasut
More information about the linux-arm-kernel
mailing list