[PULL 12/21] KVM: arm/arm64: check power_off in critical section before VCPU run

Christoffer Dall christoffer.dall at linaro.org
Wed Nov 4 06:49:51 PST 2015


From: Eric Auger <eric.auger at linaro.org>

In case a vcpu off PSCI call is called just after we executed the
vcpu_sleep check, we can enter the guest although power_off
is set. Let's check the power_off state in the critical section,
just before entering the guest.

Signed-off-by: Eric Auger <eric.auger at linaro.org>
Reported-by: Christoffer Dall <christoffer.dall at linaro.org>
Reviewed-by: Christoffer Dall <christoffer.dall at linaro.org>
Signed-off-by: Christoffer Dall <christoffer.dall at linaro.org>
---
 arch/arm/kvm/arm.c | 3 ++-
 1 file changed, 2 insertions(+), 1 deletion(-)

diff --git a/arch/arm/kvm/arm.c b/arch/arm/kvm/arm.c
index d04deeb..3b3384c 100644
--- a/arch/arm/kvm/arm.c
+++ b/arch/arm/kvm/arm.c
@@ -560,7 +560,8 @@ int kvm_arch_vcpu_ioctl_run(struct kvm_vcpu *vcpu, struct kvm_run *run)
 			run->exit_reason = KVM_EXIT_INTR;
 		}
 
-		if (ret <= 0 || need_new_vmid_gen(vcpu->kvm)) {
+		if (ret <= 0 || need_new_vmid_gen(vcpu->kvm) ||
+			vcpu->arch.power_off) {
 			local_irq_enable();
 			kvm_timer_sync_hwstate(vcpu);
 			kvm_vgic_sync_hwstate(vcpu);
-- 
2.1.2.330.g565301e.dirty




More information about the linux-arm-kernel mailing list