[PATCH 2/2] arm64: dts: exynos7: Enable HS200 mode operation

[Krzysztof Kozlowski]

2015-11-02 21:08 GMT+09:00 Alim Akhtar <alim.akhtar at samsung.com>:
> Hi Krzysztof,
>
>
> On 11/02/2015 05:28 PM, Krzysztof Kozlowski wrote:
>>
>> Subject - name of the board at the end (not the name of the SoC):
>> arm64: dts: Enable HS200 mode operation on exynos7-espresso
>>
>> 2015-11-02 19:04 GMT+09:00 Alim Akhtar <alim.akhtar at samsung.com>:
>>>
>>> This patch enables HS200 mode operation on exynos7 based
>>> espresso board.
>>> This also remove _broken-cd_ property as per mmc binding documentation
>>
>>
>> s/remove/removes/
>>
>>> which say one of the properties between broken-cd and non-removable
>>
>>
>> s/say/says/
>>
>>> should be used. And we already use _non-removable_ as emmc mounted
>>> on board which is a non-removable device.
>>>
>>> Signed-off-by: Alim Akhtar <alim.akhtar at samsung.com>
>>> ---
>>>   arch/arm64/boot/dts/exynos/exynos7-espresso.dts |    2 +-
>>>   1 file changed, 1 insertion(+), 1 deletion(-)
>>>
>>> diff --git a/arch/arm64/boot/dts/exynos/exynos7-espresso.dts
>>> b/arch/arm64/boot/dts/exynos/exynos7-espresso.dts
>>> index 8ce04a0ec928..7f19b99fc85b 100644
>>> --- a/arch/arm64/boot/dts/exynos/exynos7-espresso.dts
>>> +++ b/arch/arm64/boot/dts/exynos/exynos7-espresso.dts
>>> @@ -405,8 +405,8 @@
>>>   &mmc_0 {
>>>          status = "okay";
>>>          num-slots = <1>;
>>> -       broken-cd;
>>>          cap-mmc-highspeed;
>>> +       mmc-hs200-1_8v;
>>
>>
>> The "mmc-ddr-1_8v" should also be supported but I guess you did not
>> add it on purpose?
>>
> Well, I have not tested it, that why didn't added. Will check if this works
> then will add.
> Thanks for your comments.

Right, it would require testing... Just came to my mind. Anyway this
is up to you.

Best regards,
Krzysztof