[PATCH 1/2] mtd: spi-nor: add driver for NXP SPI Flash Interface (SPIFI)

[Joachim Eastwood]

On 30 May 2015 at 21:33, Richard Weinberger <richard at nod.at> wrote:
> Am 30.05.2015 um 20:08 schrieb Ezequiel Garcia:
>> +Richard
>>
>> On 05/30/2015 01:51 PM, Joachim Eastwood wrote:
>>> Hi Ezequiel,
>>>
>>> On 30 May 2015 at 17:43, Ezequiel Garcia <ezequiel at vanguardiasur.com.ar> wrote:
>>>> Hi Joachim,
>>>>
>>>> Looks pretty neat. I've just a couple comments.
>>>>
>>>> On 05/29/2015 02:50 PM, Joachim Eastwood wrote:
>>>>> Add SPI-NOR driver for the SPI Flash Interface (SPIFI)
>>>>> controller that is found newer NXP MCU devices.
>>>>>
>>>>> The controller supports serial SPI Flash devices with 1-, 2-
>>>>> and 4-bit width in either SPI mode 0 or 3. The controller
>>>>> can operate in either command or memory mode. In memory mode
>>>>> the Flash is exposed as normal memory and can be directly
>>>>> accessed by the CPU.
>>>>>
>>>>> Signed-off-by: Joachim Eastwood <manabian at gmail.com>
>>>>> ---
>>>>>  drivers/mtd/spi-nor/Kconfig     |  10 +
>>>>>  drivers/mtd/spi-nor/Makefile    |   1 +
>>>>>  drivers/mtd/spi-nor/nxp-spifi.c | 508 ++++++++++++++++++++++++++++++++++++++++
>>>>>  3 files changed, 519 insertions(+)
>>>>>  create mode 100644 drivers/mtd/spi-nor/nxp-spifi.c
>>>>>
>>>>> diff --git a/drivers/mtd/spi-nor/Kconfig b/drivers/mtd/spi-nor/Kconfig
>>>>> index 64a4f0edabc7..f10a37f1a4ef 100644
>>>>> --- a/drivers/mtd/spi-nor/Kconfig
>>>>> +++ b/drivers/mtd/spi-nor/Kconfig
>>>>> @@ -28,4 +28,14 @@ config SPI_FSL_QUADSPI
>>>>>         This enables support for the Quad SPI controller in master mode.
>>>>>         We only connect the NOR to this controller now.
>>>>>
>>>>> +config SPI_NXP_SPIFI
>>>>> +     tristate "NXP SPI Flash Interface (SPIFI)"
>>>>> +     depends on OF && (ARCH_LPC18XX || COMPILE_TEST)
>>>>
>>>> Since you are adding COMPILE_TEST, maybe you want
>>>> 'depends on HAS_IOMEM' as well?
>>>
>>> Since MTD depends on GENERIC_IO is that needed?
>>> Or am I confusing the config options here(?)
>>>
>>
>> I think you need HAS_IOMEM for ioremap stuff.
>> Maybe Brian or Richard will know better.
>
> Yes, if you need ioremap() your driver has to depend on HAS_IOMEM.
>
> We have GENERIC_IO to allow non-physical MTD stuff
> on architectures without io memory, namely s390 and UML.
> Some time ago I've implemented GENERIC_IO to make nandsim
> and UBI work on UML.

Got it.
Thanks Richard.

I'll send a new version of the patch within a couple of days.


regards,
Joachim Eastwood