[PATCH v2 0/6] GPIO support for BRCMSTB
Florian Fainelli
f.fainelli at gmail.com
Fri May 29 09:26:13 PDT 2015
On 28/05/15 19:14, Gregory Fong wrote:
> This patchset adds support for the GPIO controller (UPG GIO) used on Broadcom's
> various BRCMSTB SoCs (BCM7XXX and others). It uses the "basic-mmio-gpio"
> interface to try to reduce duplication of the base logic.
>
> For all existing hardware, this block hooked up to the BCM7120 L2 IRQ
> controller and so will require CONFIG_BCM7120_L2_IRQ=y.
Unless there are objections, I will take patches 5 and 6 and apply them
to soc/next.
Reviewed-by: Florian Fainelli <f.fainelli at gmail.com>
Thanks!
>
> New in v2:
> - fix license mismatch as pointed out by Paul Bolle
> - move select ARCH_WANT_OPTIONAL_GPIOLIB to separate patch
> - change to have 32 lines per bank per Linus Walleij's comments
> - allow this controller to be used as a wakeup source
> - add default GPIO number for BRCMSTB
>
> The device tree bindings from v1 were merged to the GPIO tree, so this patchset
> only contains an addition to allow GPIOs to be used as a wakeup source
> (patch 3). The initial bindings from v1 can be found at
> https://lkml.org/lkml/2015/5/6/200 .
>
> Gregory Fong (6):
> gpio: Add GPIO support for Broadcom STB SoCs
> gpio: brcmstb: Add interrupt support
> dt-bindings: brcmstb-gpio: document properties for wakeup
> gpio: brcmstb: Allow GPIOs to be wakeup sources
> ARM: brcmstb: Select ARCH_WANT_OPTIONAL_GPIOLIB
> ARM: brcmstb: Add default gpio number
>
> .../devicetree/bindings/gpio/brcm,brcmstb-gpio.txt | 26 +-
> MAINTAINERS | 7 +
> arch/arm/Kconfig | 3 +-
> arch/arm/mach-bcm/Kconfig | 1 +
> drivers/gpio/Kconfig | 9 +
> drivers/gpio/Makefile | 1 +
> drivers/gpio/gpio-brcmstb.c | 581 +++++++++++++++++++++
> 7 files changed, 626 insertions(+), 2 deletions(-)
> create mode 100644 drivers/gpio/gpio-brcmstb.c
>
--
Florian
More information about the linux-arm-kernel
mailing list