[PATCH 02/12] i2c: pxa: No need to set slave addr for i2c master mode reset

[Vaibhav Hiremath]

From: "Jett.Zhou" <jtzhou at marvell.com>

Normally i2c controller works as master, so slave addr is not needed, or it
will impact some slave device (eg. ST NFC chip) i2c accesses, because it has
the same i2c address with controller.

Signed-off-by: Jett.Zhou <jtzhou at marvell.com>
[vaibhav.hiremath at linaro.org: Updated Changelog]
Signed-off-by: Vaibhav Hiremath <vaibhav.hiremath at linaro.org>
Cc: Wolfram Sang <wsa at the-dreams.de>

Signed-off-by: Vaibhav Hiremath <vaibhav.hiremath at linaro.org>
---
 drivers/i2c/busses/i2c-pxa.c | 2 ++
 1 file changed, 2 insertions(+)

diff --git a/drivers/i2c/busses/i2c-pxa.c b/drivers/i2c/busses/i2c-pxa.c
index f4ac8c5..d4c798a 100644
--- a/drivers/i2c/busses/i2c-pxa.c
+++ b/drivers/i2c/busses/i2c-pxa.c
@@ -459,8 +459,10 @@ static void i2c_pxa_reset(struct pxa_i2c *i2c)
 	writel(I2C_ISR_INIT, _ISR(i2c));
 	writel(readl(_ICR(i2c)) & ~ICR_UR, _ICR(i2c));
 
+#ifdef CONFIG_I2C_PXA_SLAVE
 	if (i2c->reg_isar)
 		writel(i2c->slave_addr, _ISAR(i2c));
+#endif
 
 	/* set control register values */
 	writel(I2C_ICR_INIT | (i2c->fast_mode ? ICR_FM : 0), _ICR(i2c));
-- 
1.9.1