[PATCH v9 0/4]PCI: X-Gene: Add APM X-Gene v1 MSI/MSIX termination driver

[Duc Dang]

This patch set adds MSI/MSIX termination driver support for APM X-Gene v1 SoC.
APM X-Gene v1 SoC supports its own implementation of MSI, which is not compliant
to GIC V2M specification for MSI Termination.

There is single MSI block in X-Gene v1 SOC which serves all 5 PCIe ports. This MSI
block supports 2048 MSI termination ports coalesced into 16 physical HW IRQ lines
and shared across all 5 PCIe ports. As the version 5 of this patch, the total MSI
vectors this driver supports is reduced to 256 to maintain the correct set_affinity
behavior for each MSI.

v9 changes:
        1. Add more helpers for manipulating MSI messages
        2. Improve code readability
	3. Make PCI_XGENE_MSI selectable

v8 changes:
        1. Add helper to read MSI registers
        2. Resample interrupt status of the same group after handling interrupts
           in that group
        3. Error handling in case fail to allocate CPU mask for affinity setting

v7 changes:
        1. Add more error handling cases
        2. Clear spurious interrupts that may happen during driver probe
        3. Not using free_irq for chained irqs
        4. Improve GIC IRQ number look up in chained handler

v6 changes:
        1. Correctly allocate MSI with bitmap_find_next_zero_area
        2. Add notifier for CPU hotplug case
        3. Driver clean up
        4. Add more detailed information into device tree binding document
           and move the device tree binding patch before the driver/dts patch

v5 changes:
        1. Implement set_affinity for each MSI by statically allocating 2 MSI GIC IRQs
        for each X-Gene CPU core and moving MSI vectors around these GIC IRQs to steer
        them to target CPU core. As a consequence, the total MSI vectors that X-Gene v1
        supports is reduced to 256.

v4 changes:
        1. Remove affinity setting for each MSI
        2. Add description about register layout, MSI termination address and data
        3. Correct total number of MSI vectors to 2048
        4. Clean up error messages
        5. Remove unused module code

v3 changes:
        1. Implement MSI support using PCI MSI IRQ domain
        2. Only use msi_controller to store IRQ domain

v2 changes:
        1. Use msi_controller structure
        2. Remove arch hooks arch_teardown_msi_irqs and arch_setup_msi_irqs

 .../devicetree/bindings/pci/xgene-pci-msi.txt      |  68 +++
 MAINTAINERS                                        |   8 +
 arch/arm64/boot/dts/apm/apm-storm.dtsi             |  27 +
 drivers/pci/host/Kconfig                           |  10 +
 drivers/pci/host/Makefile                          |   1 +
 drivers/pci/host/pci-xgene-msi.c                   | 595 +++++++++++++++++++++
 drivers/pci/host/pci-xgene.c                       |  21 +
 7 files changed, 730 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/pci/xgene-pci-msi.txt
 create mode 100644 drivers/pci/host/pci-xgene-msi.c

-- 
1.9.1