[PATCH 1/2] PCI: iproc: directly add pci resources
Ray Jui
rjui at broadcom.com
Mon May 25 17:32:48 PDT 2015
Hi Hauke,
On 15-05-25 03:48 PM, Hauke Mehrtens wrote:
> On 05/25/2015 07:10 PM, Ray Jui wrote:
>> Hi Hauke,
>>
>> On 5/24/2015 1:37 PM, Hauke Mehrtens wrote:
>>> The resources member in the struct was pointing to a stack variable and
>>> is invalid after the the registration function returned. Remove this
>>> pointer and add it a a parameter to the function.
>>>
>>> Signed-off-by: Hauke Mehrtens <hauke at hauke-m.de>
>>> ---
>>> drivers/pci/host/pcie-iproc-bcma.c | 4 +---
>>> drivers/pci/host/pcie-iproc-platform.c | 4 +---
>>> drivers/pci/host/pcie-iproc.c | 4 ++--
>>> drivers/pci/host/pcie-iproc.h | 3 +--
>>> 4 files changed, 5 insertions(+), 10 deletions(-)
>>>
>>> diff --git a/drivers/pci/host/pcie-iproc-bcma.c b/drivers/pci/host/pcie-iproc-bcma.c
>>> index c318f19..f96b39e 100644
>>> --- a/drivers/pci/host/pcie-iproc-bcma.c
>>> +++ b/drivers/pci/host/pcie-iproc-bcma.c
>>> @@ -62,11 +62,9 @@ static int iproc_pcie_bcma_probe(struct bcma_device *bdev)
>>> res_mem.flags = IORESOURCE_MEM;
>>> pci_add_resource(&res, &res_mem);
>>>
>>> - pcie->resources = &res;
>>> -
>>> pcie->map_irq = iproc_pcie_bcma_map_irq;
>>>
>>> - ret = iproc_pcie_setup(pcie);
>>> + ret = iproc_pcie_setup(pcie, &res);
>>> if (ret) {
>>> dev_err(pcie->dev, "PCIe controller setup failed\n");
>>> return ret;
>>> diff --git a/drivers/pci/host/pcie-iproc-platform.c b/drivers/pci/host/pcie-iproc-platform.c
>>> index c8aa06f..c5fe4c1 100644
>>> --- a/drivers/pci/host/pcie-iproc-platform.c
>>> +++ b/drivers/pci/host/pcie-iproc-platform.c
>>> @@ -69,11 +69,9 @@ static int iproc_pcie_pltfm_probe(struct platform_device *pdev)
>>> return ret;
>>> }
>>>
>>> - pcie->resources = &res;
>>> -
>>> pcie->map_irq = of_irq_parse_and_map_pci;
>>>
>>> - ret = iproc_pcie_setup(pcie);
>>> + ret = iproc_pcie_setup(pcie, &res);
>>> if (ret) {
>>> dev_err(pcie->dev, "PCIe controller setup failed\n");
>>> return ret;
>>> diff --git a/drivers/pci/host/pcie-iproc.c b/drivers/pci/host/pcie-iproc.c
>>> index cef31f6..d77481e 100644
>>> --- a/drivers/pci/host/pcie-iproc.c
>>> +++ b/drivers/pci/host/pcie-iproc.c
>>> @@ -183,7 +183,7 @@ static void iproc_pcie_enable(struct iproc_pcie *pcie)
>>> writel(SYS_RC_INTX_MASK, pcie->base + SYS_RC_INTX_EN);
>>> }
>>>
>>> -int iproc_pcie_setup(struct iproc_pcie *pcie)
>>> +int iproc_pcie_setup(struct iproc_pcie *pcie, struct list_head *res)
>>> {
>>> int ret;
>>> struct pci_bus *bus;
>>> @@ -211,7 +211,7 @@ int iproc_pcie_setup(struct iproc_pcie *pcie)
>>> pcie->sysdata.private_data = pcie;
>>>
>>> bus = pci_create_root_bus(pcie->dev, 0, &iproc_pcie_ops,
>>> - &pcie->sysdata, pcie->resources);
>>> + &pcie->sysdata, res);
>>> if (!bus) {
>>> dev_err(pcie->dev, "unable to create PCI root bus\n");
>>> ret = -ENOMEM;
>>> diff --git a/drivers/pci/host/pcie-iproc.h b/drivers/pci/host/pcie-iproc.h
>>> index a333d4b..ba0a108 100644
>>> --- a/drivers/pci/host/pcie-iproc.h
>>> +++ b/drivers/pci/host/pcie-iproc.h
>>> @@ -29,7 +29,6 @@
>>> struct iproc_pcie {
>>> struct device *dev;
>>> void __iomem *base;
>>> - struct list_head *resources;
>>
>> This means we do not want to keep a copy of the resources. In the
>> future, if we need to add support to explicitly set up the
>> inbound/outbound mapping window, we need to do it in iproc_pcie_setup.
>> Is that the intention?
>
> I haven't really thought about where to configure the memory mapping,
> but I thought it would be somewhere in iproc_pcie_setup() or an method
> called from there.
> If you need it after iproc_pcie_setup() finished we should embed the
> list into the struct iproc_pcie, because currently this pointer points
> to the stack.
>
> Hauke
>
I think most likely I'll be adding the memory mapping logic in
iproc_pcie_setup(), so your current patch should be fine.
Reviewed-by: Ray Jui <rjui at broadcom.com>
Tested-by: Ray Jui <rjui at broadcom.com>
Thanks.
More information about the linux-arm-kernel
mailing list