[PATCHv2] ARM: mvebu: add support for the new Aramda 385 based Linksys boards

[Gregory CLEMENT]

Hi Imre,

On 20/05/2015 23:14, Imre Kaloz wrote:
> This patch adds support for the Linksys WRT1200AC (Caiman) and
> the Linksys WRT1900AC v2 (Cobra).
> 
> Both boards have:
> 
> - 2 Marvell 88W8864 radios
> - 1 USB 3.0 port
> - 1 USB 2.0/eSATAp port
> - 2 Ethernet interfaces connected to a 88E6176 switch (1x WAN + 4x LAN)
> - 128MB NAND flash
> - 512MB RAM
> 
> Signed-off-by: Imre Kaloz <kaloz at openwrt.org>
> 
> ---
> Changes since v1: added DSA support
> ---
> The only difference between the two boards is the radio configuration
> (2x2 vs 3x3), so everything except the leds (to be named properly)
> is in the dtsi file. When the wireless driver will be submitted
> upstream, the powertables (calibration data) will end up in the board
> specific files, tho.

it seems that you missed my comment about removing bootargs and just using
stdout-path = "serial0:115200n8";

If you agree and if there is no remark about the DSA part from Andrew, I can
take car of it while applying your patch on mvebu/dt.


Thanks,

Gregory

[...]

> --- /dev/null
> +++ b/arch/arm/boot/dts/armada-385-linksys.dtsi

[...]

> +	chosen {
> +		bootargs = "console=ttyS0,115200";
> +		stdout-path = &uart0;
Just here
> +	};


[...]
-- 
Gregory Clement, Free Electrons
Kernel, drivers, real-time and embedded Linux
development, consulting, training and support.
http://free-electrons.com