[PATCH v5 2/3] Documentation: bindings: document the Berlin ADC driver

[Jonathan Cameron]

On 18/05/15 10:19, Antoine Tenart wrote:
> Following the addition of a Berlin ADC driver, this patch adds the
> corresponding bindings documentation.
> 
> Signed-off-by: Antoine Tenart <antoine.tenart at free-electrons.com>
> Acked-by: Jonathan Cameron <jic23 at kernel.org>
Applied and pushed out as the togreg branch of iio.git.

Thanks,
> ---
>  .../devicetree/bindings/iio/adc/berlin2_adc.txt       | 19 +++++++++++++++++++
>  1 file changed, 19 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/iio/adc/berlin2_adc.txt
> 
> diff --git a/Documentation/devicetree/bindings/iio/adc/berlin2_adc.txt b/Documentation/devicetree/bindings/iio/adc/berlin2_adc.txt
> new file mode 100644
> index 000000000000..908334c6b07f
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/iio/adc/berlin2_adc.txt
> @@ -0,0 +1,19 @@
> +* Berlin Analog to Digital Converter (ADC)
> +
> +The Berlin ADC has 8 channels, with one connected to a temperature sensor.
> +It is part of the system controller register set. The ADC node should be a
> +sub-node of the system controller node.
> +
> +Required properties:
> +- compatible: must be "marvell,berlin2-adc"
> +- interrupts: the interrupts for the ADC and the temperature sensor
> +- interrupt-names: should be "adc" and "tsen"
> +
> +Example:
> +
> +adc: adc {
> +	compatible = "marvell,berlin2-adc";
> +	interrupt-parent = <&sic>;
> +	interrupts = <12>, <14>;
> +	interrupt-names = "adc", "tsen";
> +};
>