[PATCH] ARM: OMAP1: Fix section mismatch warnings for omap_cfg_reg
Tony Lindgren
tony at atomide.com
Thu May 21 11:42:07 PDT 2015
This is cleary used after init time too for example for
configuring UART wake-up events during runtime.
Signed-off-by: Tony Lindgren <tony at atomide.com>
---
arch/arm/mach-omap1/mux.c | 8 ++++----
1 file changed, 4 insertions(+), 4 deletions(-)
diff --git a/arch/arm/mach-omap1/mux.c b/arch/arm/mach-omap1/mux.c
index 667ce50..599490a 100644
--- a/arch/arm/mach-omap1/mux.c
+++ b/arch/arm/mach-omap1/mux.c
@@ -36,7 +36,7 @@
static struct omap_mux_cfg arch_mux_cfg;
#if defined(CONFIG_ARCH_OMAP730) || defined(CONFIG_ARCH_OMAP850)
-static struct pin_config __initdata_or_module omap7xx_pins[] = {
+static struct pin_config omap7xx_pins[] = {
MUX_CFG_7XX("E2_7XX_KBR0", 12, 21, 0, 20, 1, 0)
MUX_CFG_7XX("J7_7XX_KBR1", 12, 25, 0, 24, 1, 0)
MUX_CFG_7XX("E1_7XX_KBR2", 12, 29, 0, 28, 1, 0)
@@ -82,7 +82,7 @@ MUX_CFG_7XX("UART_7XX_2", 8, 1, 6, 0, 0, 0)
#endif /* CONFIG_ARCH_OMAP730 || CONFIG_ARCH_OMAP850 */
#if defined(CONFIG_ARCH_OMAP15XX) || defined(CONFIG_ARCH_OMAP16XX)
-static struct pin_config __initdata_or_module omap1xxx_pins[] = {
+static struct pin_config omap1xxx_pins[] = {
/*
* description mux mode mux pull pull pull pu_pd pu dbg
* reg offset mode reg bit ena reg
@@ -343,7 +343,7 @@ MUX_CFG("Y14_1610_CCP_DATAM", 9, 21, 6, 2, 3, 1, 2, 0, 0)
#define OMAP1XXX_PINS_SZ 0
#endif /* CONFIG_ARCH_OMAP15XX || CONFIG_ARCH_OMAP16XX */
-static int __init_or_module omap1_cfg_reg(const struct pin_config *cfg)
+static int omap1_cfg_reg(const struct pin_config *cfg)
{
static DEFINE_SPINLOCK(mux_spin_lock);
unsigned long flags;
@@ -469,7 +469,7 @@ int __init omap_mux_register(struct omap_mux_cfg *arch_mux_cfg)
/*
* Sets the Omap MUX and PULL_DWN registers based on the table
*/
-int __init_or_module omap_cfg_reg(const unsigned long index)
+int omap_cfg_reg(const unsigned long index)
{
struct pin_config *reg;
--
2.1.4
More information about the linux-arm-kernel
mailing list