[PATCH 0/2] PCI: iproc: add bcma PCIe 2.0 controller

[Bjorn Helgaas]

On Tue, May 12, 2015 at 11:22:59PM +0200, Hauke Mehrtens wrote:
> After Ray submitted the PCIe controller for the iProc devices using 
> pure device tree this adds support for the devices using bcma to scan 
> the bus. This should replaces the driver I initially send for inclusion.
> 
> @Ray The driver found in the Broadcom SDK does some more stuff:
> * setting up some DMA memory areas
> * chaining MPS and MRRS to 512
> * PHY changes:
>  * "improving" the PCIe jitter 
>  * some special initializations for the 3rd PCIe port
> 
> For me it works without these additions, but I haven't tested for 
> performance or stability or 3rd port. Can you check if this is needed 
> at all for the devices found on the market?
> 
> Hauke Mehrtens (2):
>   PCI: iproc: make of_irq_parse_and_map_pci() configurable
>   PCI: iproc: add bcma pcie driver
> 
>  drivers/pci/host/Kconfig               |  11 ++++
>  drivers/pci/host/Makefile              |   1 +
>  drivers/pci/host/pcie-iproc-bcma.c     | 112 +++++++++++++++++++++++++++++++++
>  drivers/pci/host/pcie-iproc-platform.c |   2 +
>  drivers/pci/host/pcie-iproc.c          |   2 +-
>  drivers/pci/host/pcie-iproc.h          |   1 +
>  6 files changed, 128 insertions(+), 1 deletion(-)
>  create mode 100644 drivers/pci/host/pcie-iproc-bcma.c

Applied to pci/host-iproc for v4.2 with acks from Ray and Rafał, thanks!

I corrected some typos, the most important being MODULE_LICENSE, where I
changed "GPLv2" to "GPL v2".  See license_is_gpl_compatible() and
eed6542dd53f ("PCI: generic: Fix GPL v2 license string typo").

Bjorn