[PATCHv3 10/10] CLK: TI: always enable DESHDCP clock

[Tero Kristo]

On 05/06/2015 01:08 PM, Tomi Valkeinen wrote:
> DESHDCP clock is needed on DRA7 based SoCs to enable the DSS IP. That
> clock is an odd one, as it is not supposed to be any kind of core clock
> for DSS, and we don't even support HDCP, but the clock is still needed
> even for the HWMOD framework to be able to reset the DSS IP.
>
> As there's no support for multiple core clocks in the HWMOD framework,
> we don't have any obvious place to enable this clock when DSS IP is
> being enabled.
>
> Furthermore, the HDMI on OMAP5 DSS is the same as on DRA7, and OMAP5
> does not have any such clock configuration bit. This suggests that on
> OMAP5 the DESHDCP clock is always enabled, and for DRA7 we have the
> possibility to gate it.
>
> So, as we don't have any clean way to enable and disable the clock
> based on the need, this patch enables the clock at boot time, making it
> work similarly to OMAP5.
>
> Signed-off-by: Tomi Valkeinen <tomi.valkeinen at ti.com>
> ---
>   drivers/clk/ti/clk-7xx.c | 7 ++++++-
>   1 file changed, 6 insertions(+), 1 deletion(-)
>
> diff --git a/drivers/clk/ti/clk-7xx.c b/drivers/clk/ti/clk-7xx.c
> index 2dd956b9affa..63b8323df918 100644
> --- a/drivers/clk/ti/clk-7xx.c
> +++ b/drivers/clk/ti/clk-7xx.c
> @@ -312,7 +312,7 @@ static struct ti_dt_clk dra7xx_clks[] = {
>   int __init dra7xx_dt_clk_init(void)
>   {
>   	int rc;
> -	struct clk *abe_dpll_mux, *sys_clkin2, *dpll_ck;
> +	struct clk *abe_dpll_mux, *sys_clkin2, *dpll_ck, *hdcp_ck;
>
>   	ti_dt_clocks_register(dra7xx_clks);
>
> @@ -348,5 +348,10 @@ int __init dra7xx_dt_clk_init(void)
>   	if (rc)
>   		pr_err("%s: failed to set USB_DPLL M2 OUT\n", __func__);
>
> +	hdcp_ck = clk_get_sys(NULL, "dss_deshdcp_clk");
> +	rc = clk_prepare_enable(hdcp_ck);
> +	if (rc)
> +		pr_err("%s: failed to set dss_deshdcp_clk\n", __func__);
> +
>   	return rc;
>   }
>

You should rather use the assigned-clock properties in DT to accomplish 
this, the manual clock tweaks under the drivers/clk/ti/clk-* files 
should be converted to DT setup also.

-Tero