[PATCH v3] arm, imx6, dts: add DT for aristainetos2 board

[Philipp Zabel]

Hi Heiko,

Am Mittwoch, den 20.05.2015, 07:31 +0200 schrieb Heiko Schocher:
[...]
> diff --git a/arch/arm/boot/dts/imx6dl-aristainetos2_4.dts b/arch/arm/boot/dts/imx6dl-aristainetos2_4.dts
> new file mode 100644
> index 0000000..780fc42
> --- /dev/null
> +++ b/arch/arm/boot/dts/imx6dl-aristainetos2_4.dts
> @@ -0,0 +1,174 @@
> +/*
> + * support fot the imx6 based aristainetos2 board

Typo, "support for".

> + *
> + * Copyright (C) 2015 Heiko Schocher <hs at denx.de>
> + *
> + * This file is dual-licensed: you can use it either under the terms
> + * of the GPL or the X11 license, at your option. Note that this dual
> + * licensing only applies to this file, and not this project as a
> + * whole.
> + *
> + *  a) This file is free software; you can redistribute it and/or
> + *     modify it under the terms of the GNU General Public License as
> + *     published by the Free Software Foundation; either version 2 of
> + *     the License, or (at your option) any later version.
> + *
> + *     This file is distributed in the hope that it will be useful,
> + *     but WITHOUT ANY WARRANTY; without even the implied warranty of
> + *     MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.  See the
> + *     GNU General Public License for more details.
> + *
> + *     You should have received a copy of the GNU General Public
> + *     License along with this file; if not, write to the Free
> + *     Software Foundation, Inc., 51 Franklin St, Fifth Floor, Boston,
> + *     MA 02110-1301 USA

checkpatch warns that you should not include this paragraph because the
mail address might change in the future and it is contained in COPYING.

[...]
> +/dts-v1/;
> +#include "imx6dl.dtsi"
> +#include "imx6qdl-aristainetos2.dtsi"
> +
> +/ {
> +	model = "aristainetos2 i.MX6 Dual Lite Board 4";
> +	compatible = "fsl,imx6dl";

Doesn't this board get its own compatible?

[...]
> +	display0: display at di0 {
> +		#address-cells = <1>;
> +		#size-cells = <0>;
> +		compatible = "fsl,imx-parallel-display";
> +		interface-pix-fmt = "rgb24";

It's ok to keep this property for now, but in the future I'd like it to
be removed. The panel driver should provide all necessary information
using drm_display_info_set_bus_formats. The imx parallel-display driver
then needs to be made aware of the connector display_info->bus_formats.

[...]
> diff --git a/arch/arm/boot/dts/imx6dl-aristainetos2_7.dts b/arch/arm/boot/dts/imx6dl-aristainetos2_7.dts
> new file mode 100644
> index 0000000..14cf4e8
> --- /dev/null
> +++ b/arch/arm/boot/dts/imx6dl-aristainetos2_7.dts
> @@ -0,0 +1,103 @@
> +/*
> + * support fot the imx6 based aristainetos2 board

Typo, "support for".

> + * Copyright (C) 2015 Heiko Schocher <hs at denx.de>
> + *
> + * This file is dual-licensed: you can use it either under the terms
> + * of the GPL or the X11 license, at your option. Note that this dual
> + * licensing only applies to this file, and not this project as a
> + * whole.
> + *
> + *  a) This file is free software; you can redistribute it and/or
> + *     modify it under the terms of the GNU General Public License as
> + *     published by the Free Software Foundation; either version 2 of
> + *     the License, or (at your option) any later version.
> + *
> + *     This file is distributed in the hope that it will be useful,
> + *     but WITHOUT ANY WARRANTY; without even the implied warranty of
> + *     MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.  See the
> + *     GNU General Public License for more details.
> + *
> + *     You should have received a copy of the GNU General Public
> + *     License along with this file; if not, write to the Free
> + *     Software Foundation, Inc., 51 Franklin St, Fifth Floor, Boston,
> + *     MA 02110-1301 USA

Same comment as above.

[...]
> +/ {
> +	model = "aristainetos2 i.MX6 Dual Lite Board 7";
> +	compatible = "fsl,imx6dl";

Same comment as above.

> +&ldb {
> +	status = "okay";
> +
> +	lvds-channel at 0 {
> +		fsl,data-mapping = "spwg";
> +		fsl,data-width = <24>;
> +		status = "okay";
> +
> +		display-timings {
> +			native-mode = <&timing0>;
> +			timing0: 800x480p60 {
> +				clock-frequency = <33246000>;
> +				hactive = <800>;
> +				vactive = <480>;
> +				hfront-porch = <88>;
> +				hback-porch = <88>;
> +				hsync-len = <80>;
> +				vback-porch = <10>;
> +				vfront-porch = <10>;
> +				vsync-len = <25>;
> +			};
> +		};
> +	};

What panel is this? I'd prefer if you used the panel-simple driver here
and connected it to the ldb channel using OF graph bindings same as the
parallel display above. That would allow to remove the fsl,data-mapping
and fsl,data-width properties and the display-timings node.

> +};
> diff --git a/arch/arm/boot/dts/imx6qdl-aristainetos2.dtsi b/arch/arm/boot/dts/imx6qdl-aristainetos2.dtsi
> new file mode 100644
> index 0000000..eac7c3b
> --- /dev/null
> +++ b/arch/arm/boot/dts/imx6qdl-aristainetos2.dtsi
> @@ -0,0 +1,634 @@
> +/*
> + * support fot the imx6 based aristainetos2 board

Typo, "support for". Also, maybe s/board/boards/ as this contains the
common parts for both the 4 and 7 variant?

> + *
> + * Copyright (C) 2015 Heiko Schocher <hs at denx.de>
> + *
> + * This file is dual-licensed: you can use it either under the terms
> + * of the GPL or the X11 license, at your option. Note that this dual
> + * licensing only applies to this file, and not this project as a
> + * whole.
> + *
> + *  a) This file is free software; you can redistribute it and/or
> + *     modify it under the terms of the GNU General Public License as
> + *     published by the Free Software Foundation; either version 2 of
> + *     the License, or (at your option) any later version.
> + *
> + *     This file is distributed in the hope that it will be useful,
> + *     but WITHOUT ANY WARRANTY; without even the implied warranty of
> + *     MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.  See the
> + *     GNU General Public License for more details.
> + *
> + *     You should have received a copy of the GNU General Public
> + *     License along with this file; if not, write to the Free
> + *     Software Foundation, Inc., 51 Franklin St, Fifth Floor, Boston,
> + *     MA 02110-1301 USA

Same comment as above.

[...]
> +&i2c1 {
> +	pinctrl-names = "default";
> +	pinctrl-0 = <&pinctrl_i2c1>;
> +	status = "okay";
> +
> +	pmic at 58 {
> +		compatible = "dialog,da9063";

This should be "dlg,da9063" as per
Documentation/devicetree/bindings/mfd/da9063.txt.

[...]
> +&i2c4 {
> +	clocks = <&clks IMX6DL_CLK_I2C4>;

The clocks property is already contained in imx6dl.dtsi

[...]
> +&fec
> +&gpmi
> +&pcie
> +&pwm1
> +&uart1
> +&uart2
> +&uart3
> +&uart4
> +&usbh1
> +&usbotg
> +&usdhc1
> +&usdhc2
> +&iomuxc

Do all aristainetos2 boards have all of these ports routed out? (Should
the status = "okay" properties be set here, or in the per-board .dts
files?)

regards
Philipp