[RFC PATCH 1/2] devicetree: Add devicetree bindings documentation for ZynqMP GQSPI

[Ranjit Waghmode]

Add bindings documentation for GQSPI controller driver used by
Zynq Ultrascale+ MPSoC

Signed-off-by: Ranjit Waghmode <ranjit.waghmode at xilinx.com>
---
 .../devicetree/bindings/spi/spi-zynqmp-qspi.txt    | 26 ++++++++++++++++++++++
 1 file changed, 26 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/spi/spi-zynqmp-qspi.txt

diff --git a/Documentation/devicetree/bindings/spi/spi-zynqmp-qspi.txt b/Documentation/devicetree/bindings/spi/spi-zynqmp-qspi.txt
new file mode 100644
index 0000000..cec6330
--- /dev/null
+++ b/Documentation/devicetree/bindings/spi/spi-zynqmp-qspi.txt
@@ -0,0 +1,26 @@
+Xilinx Zynq UltraScale+ MPSoC GQSPI controller Device Tree Bindings
+-------------------------------------------------------------------
+
+Required properties:
+- compatible		: Should be "xlnx,zynqmp-qspi-1.0".
+- reg			: Physical base address and size of GQSPI registers map.
+- interrupts		: Property with a value describing the interrupt
+			  number.
+- interrupt-parent	: Must be core interrupt controller.
+- clock-names		: List of input clock names - "ref_clk", "pclk"
+			  (See clock bindings for details).
+- clocks		: Clock phandles (see clock bindings for details).
+
+Optional properties:
+- num-cs		: Number of chip selects used.
+
+Example:
+	qspi: spi at ff0f0000 {
+		compatible = "xlnx,zynqmp-qspi-1.0";
+		clock-names = "ref_clk", "pclk";
+		clocks = <&misc_clk &misc_clk>;
+		interrupts = <0 15 4>;
+		interrupt-parent = <&gic>;
+		num-cs = <1>;
+		reg = <0x0 0xff0f0000 0x1000 0x0 0xc0000000 0x8000000>;
+	};
--
2.1.2