[RFC PATCH v1 3/3] Documentation: DT: Add Hisilicon PCIe host binding

[Zhou Wang]

This patch adds related DTS binding document for Hisilicon PCIe host driver.

Signed-off-by: Zhou Wang <wangzhou1 at hisilicon.com>
---
 .../devicetree/bindings/pci/hisilicon-pcie.txt     | 46 ++++++++++++++++++++++
 1 file changed, 46 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/pci/hisilicon-pcie.txt

diff --git a/Documentation/devicetree/bindings/pci/hisilicon-pcie.txt b/Documentation/devicetree/bindings/pci/hisilicon-pcie.txt
new file mode 100644
index 0000000..c24578d
--- /dev/null
+++ b/Documentation/devicetree/bindings/pci/hisilicon-pcie.txt
@@ -0,0 +1,46 @@
+Hisilicon PCIe host bridge DT description
+
+Hisilicon PCIe host controller is based on Designware PCI core.
+It shares common functions with PCIe Designware core driver and inherits
+common properties defined in
+Documentation/devicetree/bindings/pci/designware-pci.txt.
+
+Additional properties are described here:
+
+Required properties:
+- compatible: Should contain "hisilicon,hip05-pcie".
+- reg: Should contain rc_dbi, subctrl, config registers location and length.
+- reg-names: Must include the following entries:
+  "rc_dbi": controller configuration registers;
+  "subctrl": whole PCIe hosts configuration registers;
+  "config": PCIe configuration space registers.
+- msi-parent: Should be its_pcie which is an its receiving MSI interrupts.
+- port-id: Should be 0, 1, 2 or 3.
+
+Optional properties:
+- status: Either "ok" or "disabled".
+- dma-coherent: Present if dma operations are coherent.
+
+Example:
+	pcie at 0xb0080000 {
+		compatible = "hisilicon,hip05-pcie", "snps,dw-pcie";
+		reg = <0 0xb0080000 0 0x10000>, <0 0xb0000000 0 0x10000>,
+		      <0x220 0x00000000 0 0x1000>;
+		reg-names = "rc_dbi", "subctrl", "config";
+		bus-range = <0  15>;
+		msi-parent = <&its_pcie>;
+		#address-cells = <3>;
+		#size-cells = <2>;
+		device_type = "pci";
+		dma-coherent;
+		ranges = <0x82000000 0 0xb4100000 0x220 0x00100000 0 0x00f00000>;
+		num-lanes = <8>;
+		port-id = <1>;
+		#interrupts-cells = <1>;
+		interrupts-map-mask = <0xf800 0 0 7>;
+		interrupts-map = <0x0 0 0 1 &mbigen_pcie 1 10
+				  0x0 0 0 2 &mbigen_pcie 2 11
+				  0x0 0 0 3 &mbigen_pcie 3 12
+				  0x0 0 0 4 &mbigen_pcie 4 13>;
+		status = "ok";
+	};
-- 
1.9.1