[PATCH] ARM: fix BE8 module loading

[Arnd Bergmann]

The new veneer support for loadable modules on ARM uses the
__opcode_to_mem_thumb32() function to count R_ARM_THM_CALL
and R_ARM_THM_JUMP24 relocations.

However, this function is not defined for big-endian kernels
on ARMv5 or before, causing a compile-time error:

arch/arm/kernel/module-plts.c: In function 'count_plts':
arch/arm/kernel/module-plts.c:124:9: error: implicit declaration of function '__opcode_to_mem_thumb32' [-Werror=implicit-function-declaration]
         __opcode_to_mem_thumb32(0x07ff2fff)))
         ^

As we know that this part of the function is only needed for
Thumb2 kernels, and that those can never happen with BE8,
we can avoid the error by enclosing the code in an #ifdef.

Signed-off-by: Arnd Bergmann <arnd at arndb.de>
Fixes: 7d485f647c1 ("ARM: 8220/1: allow modules outside of bl range")
---
Found with the randconfig builder on linux-next.

diff --git a/arch/arm/kernel/module-plts.c b/arch/arm/kernel/module-plts.c
index 71a65c49871d..097e2e201b9f 100644
--- a/arch/arm/kernel/module-plts.c
+++ b/arch/arm/kernel/module-plts.c
@@ -118,11 +118,13 @@ static unsigned int count_plts(Elf32_Addr base, const Elf32_Rel *rel, int num)
 					   __opcode_to_mem_arm(0x00ffffff)))
 				ret++;
 			break;
+#ifdef CONFIG_THUMB2_KERNEL
 		case R_ARM_THM_CALL:
 		case R_ARM_THM_JUMP24:
 			if (!duplicate_rel(base, rel, i,
 					   __opcode_to_mem_thumb32(0x07ff2fff)))
 				ret++;
+#endif
 		}
 	return ret;
 }