[PATCH] Show proper respect for Heinrich Hertz by using the correct unit for frequency

[Russell King - ARM Linux]

On Mon, May 11, 2015 at 11:39:08PM +0200, Andreas Färber wrote:
> Am 11.05.2015 um 15:19 schrieb Russell King - ARM Linux:
> > The SI unit of frequency is Hertz, named after Heinrich Hertz, and is
> > given the symbol "Hz" to denote this.  "hz" is not the unit of frequency,
> > and is in fact meaningless.
> > 
> > Fix arch/arm to correctly use "Hz", thereby acknowledging Heinrich Hertz
> > contribution to the modern world.
> > 
> > Signed-off-by: Russell King <rmk+kernel at arm.linux.org.uk>
> 
> Nice. :) Since you're being exact, should it be "Hertz' contribution"?
> 
> > diff --git a/arch/arm/boot/dts/omap3-cm-t3517.dts b/arch/arm/boot/dts/omap3-cm-t3517.dts
> > index f5b5a1d96cd7..53ae04f9104d 100644
> > --- a/arch/arm/boot/dts/omap3-cm-t3517.dts
> > +++ b/arch/arm/boot/dts/omap3-cm-t3517.dts
> > @@ -66,7 +66,7 @@
> >  
> >  	otg_drv_vbus: pinmux_otg_drv_vbus {
> >  		pinctrl-single,pins = <
> > -			OMAP3_CORE1_IOPAD(0x2210, PIN_INPUT_PULLDOWN | MUX_MODE0) /* rmii_50Mhz_clk.usb0_drvvbus */
> > +			OMAP3_CORE1_IOPAD(0x2210, PIN_INPUT_PULLDOWN | MUX_MODE0) /* rmii_50MHz_clk.usb0_drvvbus */
> 
> This one looks like an identifier - did you check where it comes from
> and whether it needs to be fixed there as well?

There isn't any other reference to it in arch/arm (if there were, the
grep to find these would itself have found it.)

-- 
FTTC broadband for 0.8mile line: currently at 10.5Mbps down 400kbps up
according to speedtest.net.