[PATCH 01/13] ARM: STi: STiH407: Add DT nodes for for PWM

[Lee Jones]

Supply top level nodes for the STiH407 based development boards.
The Pinctrl configuration has already been applied, so the only
missing piece of the DT puzzle is for a board's DTB to enable
the nodes.

Signed-off-by: Ajit Pal Singh <ajitpal.singh at st.com>
Signed-off-by: Lee Jones <lee.jones at linaro.org>
---
 arch/arm/boot/dts/stih407.dtsi | 28 ++++++++++++++++++++++++++++
 1 file changed, 28 insertions(+)

diff --git a/arch/arm/boot/dts/stih407.dtsi b/arch/arm/boot/dts/stih407.dtsi
index 3efa3b2..2c560fc3 100644
--- a/arch/arm/boot/dts/stih407.dtsi
+++ b/arch/arm/boot/dts/stih407.dtsi
@@ -147,5 +147,33 @@
 				};
 			};
 		};
+
+		/* COMMS PWM Module */
+		pwm0: pwm at 9810000 {
+			compatible	= "st,sti-pwm";
+			status		= "disabled";
+			#pwm-cells	= <2>;
+			reg		= <0x9810000 0x68>;
+			pinctrl-names	= "default";
+			pinctrl-0	= <&pinctrl_pwm0_chan0_default>;
+			clock-names	= "pwm";
+			clocks		= <&clk_sysin>;
+		};
+
+		/* SBC PWM Module */
+		pwm1: pwm at 9510000 {
+			compatible	= "st,sti-pwm";
+			status		= "disabled";
+			#pwm-cells	= <2>;
+			reg		= <0x9510000 0x68>;
+			pinctrl-names	= "default";
+			pinctrl-0	= <&pinctrl_pwm1_chan0_default
+					&pinctrl_pwm1_chan1_default
+					&pinctrl_pwm1_chan2_default
+					&pinctrl_pwm1_chan3_default>;
+			clock-names	= "pwm";
+			clocks		= <&clk_sysin>;
+			st,pwm-num-chan = <4>;
+		};
 	};
 };
-- 
1.9.1