[PATCH 1/2] mmc: sdhci-sirf: fix the tuning count in platform_execute_tuning
Ulf Hansson
ulf.hansson at linaro.org
Tue May 5 01:35:18 PDT 2015
On 27 April 2015 at 10:15, Barry Song <21cnbao at gmail.com> wrote:
> From: Weijun Yang <Weijun.Yang at csr.com>
>
> hardware has 16bit to record the tuning count, so fix it to 16384.
> at the same time, tuned_phases[SIRF_TUNING_COUNT] is useless as the
> array is never used, so move it to a variant.
>
> Signed-off-by: Weijun Yang <Weijun.Yang at csr.com>
> Signed-off-by: Barry Song <Baohua.Song at csr.com>
Thanks, applied!
Kind regards
Uffe
> ---
> drivers/mmc/host/sdhci-sirf.c | 9 +++++----
> 1 file changed, 5 insertions(+), 4 deletions(-)
>
> diff --git a/drivers/mmc/host/sdhci-sirf.c b/drivers/mmc/host/sdhci-sirf.c
> index 32848eb..2201f76 100644
> --- a/drivers/mmc/host/sdhci-sirf.c
> +++ b/drivers/mmc/host/sdhci-sirf.c
> @@ -17,7 +17,7 @@
>
> #define SDHCI_CLK_DELAY_SETTING 0x4C
> #define SDHCI_SIRF_8BITBUS BIT(3)
> -#define SIRF_TUNING_COUNT 128
> +#define SIRF_TUNING_COUNT 16384
>
> struct sdhci_sirf_priv {
> int gpio_cd;
> @@ -46,7 +46,7 @@ static void sdhci_sirf_set_bus_width(struct sdhci_host *host, int width)
> static int sdhci_sirf_execute_tuning(struct sdhci_host *host, u32 opcode)
> {
> int tuning_seq_cnt = 3;
> - u8 phase, tuned_phases[SIRF_TUNING_COUNT];
> + int phase;
> u8 tuned_phase_cnt = 0;
> int rc = 0, longest_range = 0;
> int start = -1, end = 0, tuning_value = -1, range = 0;
> @@ -58,6 +58,7 @@ static int sdhci_sirf_execute_tuning(struct sdhci_host *host, u32 opcode)
>
> retry:
> phase = 0;
> + tuned_phase_cnt = 0;
> do {
> sdhci_writel(host,
> clock_setting | phase,
> @@ -65,7 +66,7 @@ retry:
>
> if (!mmc_send_tuning(mmc)) {
> /* Tuning is successful at this tuning point */
> - tuned_phases[tuned_phase_cnt++] = phase;
> + tuned_phase_cnt++;
> dev_dbg(mmc_dev(mmc), "%s: Found good phase = %d\n",
> mmc_hostname(mmc), phase);
> if (start == -1)
> @@ -85,7 +86,7 @@ retry:
> start = -1;
> end = range = 0;
> }
> - } while (++phase < ARRAY_SIZE(tuned_phases));
> + } while (++phase < SIRF_TUNING_COUNT);
>
> if (tuned_phase_cnt && tuning_value > 0) {
> /*
> --
> 2.3.5
>
More information about the linux-arm-kernel
mailing list