[PATCH 0/4] Enable SPARSE_IRQ for omap1
Tony Lindgren
tony at atomide.com
Mon May 4 12:52:18 PDT 2015
Hi all,
Here are few patches to enable SPARSE_IRQ on omap1.
Note that after this set removing the users for irqs.h
and making omap1 use the clock framework are needed to
get close to multiarch booting on omap1.
These are against v4.1-rc1, and also require the MPUIO fix:
[PATCH] gpio: omap: Fix regression for MPUIO interrupts
Regards,
Tony
Tony Lindgren (4):
ARM: OMAP1: Move UART defines to prepare for sparse IRQ
ARM: OMAP1: Switch to use generic irqchip in preparation for sparse
IRQ
ARM: omap1: Switch to use MULTI_IRQ
ARM: OMAP1: Change interrupt numbering for sparse IRQ
arch/arm/Kconfig | 2 +
arch/arm/mach-omap1/ams-delta-fiq-handler.S | 3 +-
arch/arm/mach-omap1/board-ams-delta.c | 1 +
arch/arm/mach-omap1/board-fsample.c | 1 +
arch/arm/mach-omap1/board-generic.c | 1 +
arch/arm/mach-omap1/board-h2.c | 1 +
arch/arm/mach-omap1/board-h3.c | 1 +
arch/arm/mach-omap1/board-htcherald.c | 1 +
arch/arm/mach-omap1/board-innovator.c | 1 +
arch/arm/mach-omap1/board-nokia770.c | 1 +
arch/arm/mach-omap1/board-osk.c | 1 +
arch/arm/mach-omap1/board-palmte.c | 1 +
arch/arm/mach-omap1/board-palmtt.c | 1 +
arch/arm/mach-omap1/board-palmz71.c | 1 +
arch/arm/mach-omap1/board-perseus2.c | 1 +
arch/arm/mach-omap1/board-sx1.c | 1 +
arch/arm/mach-omap1/board-voiceblue.c | 1 +
arch/arm/mach-omap1/common.h | 5 +-
arch/arm/mach-omap1/dma.c | 2 +-
arch/arm/mach-omap1/i2c.c | 3 +-
arch/arm/mach-omap1/include/mach/entry-macro.S | 39 ------
arch/arm/mach-omap1/include/mach/irqs.h | 124 ++++++++++---------
arch/arm/mach-omap1/include/mach/serial.h | 5 -
arch/arm/mach-omap1/include/mach/soc.h | 4 +
arch/arm/mach-omap1/irq.c | 157 +++++++++++++++----------
arch/arm/mach-omap1/timer.c | 4 +-
arch/arm/plat-omap/dma.c | 4 +
include/uapi/linux/serial_reg.h | 3 +
28 files changed, 190 insertions(+), 180 deletions(-)
delete mode 100644 arch/arm/mach-omap1/include/mach/entry-macro.S
--
2.1.4
More information about the linux-arm-kernel
mailing list