[PATCH v5 2/3] I2C: mediatek: Add driver for MediaTek I2C controller
eddie.huang at mediatek.com
Tue Mar 31 19:11:17 PDT 2015
On Tue, 2015-03-31 at 19:52 +0200, Sascha Hauer wrote:
> On Tue, Mar 31, 2015 at 07:50:58PM +0800, Eddie Huang wrote:
> > Hi Sascha,
> > On Tue, 2015-03-31 at 15:08 +0800, Eddie Huang wrote:
> > > Hi Sascha,
> > >
> > > > > > speed <= 400000 here to make this more obvious?
> > > > > There are two cases, not only speed<=400000, but I2C_MASTER_WRRD. I tend
> > > > > to keep it.
> > > >
> > > > Still it looks strange. You only ever write this default value to the
> > > > register. Putting this register write under an if() seems bogus since
> > > > the same value will be in the register the next time this code is
> > > > executed. It looks like you should move this register write to some
> > > > initialization function.
> > > OK, move to mtk_i2c_init_hw function
> > >
> > Sorry for my negligence. Write-then-read (I2C_MASTER_WRRD) decides
> > according to each I2C transfer, so I still need to judge whether set
> > I2C_CONTROL_RS and DELAY_LEN here. Other control setting can move to
> > init function.
> You need to decide whether you have to set the I2C_CONTROL_RS bit, but
> you don't need to write the same value to the DELAY_LEN register each
> time. It won't change under your hood.
Yes, you are right. DELAY_LEN should only be set one time in init
function. Thanks your correction.
More information about the linux-arm-kernel