[PATCH 3/3] ahci: st: st_configure_oob must be called after IP is clocked.

[Peter Griffin]

Currently the ahci_st driver will hang the system on probe, as the
st_configure_oob function does some register writes before the IP
is clocked. This patch moves the function call to after
ahci_platform_enable_resources (which enables the IP clock), and
resolves the hang.

Addtionally st_ahci_configure_oob should be called in the st_ahci_resume
function, so we also rectify that ensuring it is also called after
the IP clock has been enabled.

Signed-off-by: Peter Griffin <peter.griffin at linaro.org>
Acked-by: Lee Jones <lee.jones at linaro.org>
Acked-by: Maxime Coquelin <maxime.coquelin at st.com>
---
 drivers/ata/ahci_st.c | 6 ++++--
 1 file changed, 4 insertions(+), 2 deletions(-)

diff --git a/drivers/ata/ahci_st.c b/drivers/ata/ahci_st.c
index bc971af..ea0ff00 100644
--- a/drivers/ata/ahci_st.c
+++ b/drivers/ata/ahci_st.c
@@ -68,8 +68,6 @@ static int st_ahci_deassert_resets(struct device *dev)
 		}
 	}
 
-	st_ahci_configure_oob(drv_data->hpriv->mmio);
-
 	if (drv_data->sw_rst) {
 		err = reset_control_deassert(drv_data->sw_rst);
 		if (err) {
@@ -172,6 +170,8 @@ static int st_ahci_probe(struct platform_device *pdev)
 	if (err)
 		return err;
 
+	st_ahci_configure_oob(drv_data->hpriv->mmio);
+
 	err = ahci_platform_init_host(pdev, hpriv, &st_ahci_port_info,
 				      &ahci_platform_sht);
 	if (err) {
@@ -222,6 +222,8 @@ static int st_ahci_resume(struct device *dev)
 		return err;
 	}
 
+	st_ahci_configure_oob(drv_data->hpriv->mmio);
+
 	return ahci_platform_resume_host(dev);
 }
 #endif
-- 
1.9.1