[PATCH 2/4] ARM: DT: apq8064: Add ADM device node

[Andy Gross]

This patch adds support for the ADM DMA on the APQ8064 SOC.

Signed-off-by: Andy Gross <agross at codeaurora.org>
---
 arch/arm/boot/dts/qcom-apq8064.dtsi |   21 +++++++++++++++++++++
 1 file changed, 21 insertions(+)

diff --git a/arch/arm/boot/dts/qcom-apq8064.dtsi b/arch/arm/boot/dts/qcom-apq8064.dtsi
index b3154c0..0f24334 100644
--- a/arch/arm/boot/dts/qcom-apq8064.dtsi
+++ b/arch/arm/boot/dts/qcom-apq8064.dtsi
@@ -2,6 +2,7 @@
 
 #include "skeleton.dtsi"
 #include <dt-bindings/clock/qcom,gcc-msm8960.h>
+#include <dt-bindings/reset/qcom,gcc-msm8960.h>
 #include <dt-bindings/clock/qcom,mmcc-msm8960.h>
 #include <dt-bindings/soc/qcom,gsbi.h>
 #include <dt-bindings/interrupt-controller/arm-gic.h>
@@ -349,5 +350,25 @@
 				pinctrl-0 = <&sdc4_gpios>;
 			};
 		};
+
+		adm_dma: dma at 18320000 {
+			compatible = "qcom,adm";
+			reg = <0x18320000 0xE0000>;
+			interrupts = <GIC_SPI 171 IRQ_TYPE_NONE>;
+			#dma-cells = <1>;
+
+			clocks = <&gcc ADM0_CLK>, <&gcc ADM0_PBUS_CLK>;
+			clock-names = "core", "iface";
+
+			resets = <&gcc ADM0_RESET>,
+				 <&gcc ADM0_PBUS_RESET>,
+				 <&gcc ADM0_C0_RESET>,
+				 <&gcc ADM0_C1_RESET>,
+				 <&gcc ADM0_C2_RESET>;
+			reset-names = "clk", "pbus", "c0", "c1", "c2";
+			qcom,ee = <1>;
+
+			status = "disabled";
+		};
 	};
 };
-- 
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,
hosted by The Linux Foundation