[PATCH v2 10/10] drivers: PL011: add support for the ARM SBSA generic UART

[Andre Przywara]

On 12/03/15 13:49, Russell King - ARM Linux wrote:
> On Thu, Mar 12, 2015 at 01:43:17PM +0000, Andre Przywara wrote:
>> Hi Russel,
>>
>> thanks a lot for looking at the patches!
>>
>> On 12/03/15 10:52, Russell King - ARM Linux wrote:
>>> On Wed, Mar 04, 2015 at 05:59:54PM +0000, Andre Przywara wrote:
>>>> +module_platform_driver(arm_sbsa_uart_platform_driver);
>>>
>>> No need to open code the initialisation, rather than using the
>>> module_*_driver() helper macros to avoid the problem which Dave mentioned.
>>>
>>> These macros are only there to avoid having to write out the same boiler
>>> plate in loads of simple drivers.  As soon as a driver has more than one
>>> device driver structure in it, it needs to be open coded.
>>
>> Actually I prepared this already for the ACPI guys, which want to stuff
>> their ACPI table match function in there - I think then we need the open
>> coded version. So if you don't mind too much, I'd like to keep it like
>> this and hope for someone to actually use it ;-)
> 
> Either your statement is ambiguous, or I'm not understanding you.
> 
> You can't "keep it like this" where "this" is the above code.  The
> above will fail if the driver is built as a module, and cause a build
> time error.  That is not acceptable.

Oh, you are right, I was forgetting about that one, sorry.
I meant I'd rather leave it open coded, but of course I will fix the
module issue.

Cheers,
Andre.