[PATCH v5 3/3] ARM: dts: igep00x0: add wl18xx bindings

[Eliad Peller]

On Tue, Mar 10, 2015 at 12:49 AM, Tony Lindgren <tony at atomide.com> wrote:
> * Eliad Peller <eliad at wizery.com> [150309 14:03]:
>> On Mon, Mar 9, 2015 at 9:50 PM, Arnd Bergmann <arnd at arndb.de> wrote:
>> > On Monday 09 March 2015 17:36:42 Eliad Peller wrote:
>> >> --- a/arch/arm/boot/dts/omap3-igep0030-rev-g.dts
>> >> +++ b/arch/arm/boot/dts/omap3-igep0030-rev-g.dts
>> >> @@ -64,4 +64,13 @@
>> >>         vmmc-supply = <&lbep5clwmc_wlen>;
>> >>         bus-width = <4>;
>> >>         non-removable;
>> >> +
>> >> +       #address-cells = <1>;
>> >> +       #size-cells = <0>;
>> >> +       wlcore: wlcore at 2 {
>> >> +               compatible = "ti,wl1835";
>> >> +               reg = <2>;
>> >> +               interrupt-parent = <&gpio5>;
>> >> +               interrupts = <8 IRQ_TYPE_NONE>;
>> >> +       };
>> >>
>> >
>> > Why IRQ_TYPE_NONE?
>> >
>> i simply mirrored the current board file (which only sets the irq number).
>>
>> > I was expecting you to remove all calls to legacy_init_wl12xx from this file,
>> > including the ones for wl12xx aside from the wl18xx ones you removed, but
>> > if that's enough to clean out the platform_data handling from the wlcore
>> > driver, it's good enough as a start.
>> not sure i'm following - can you elaborate?
>>
>> i'll summarize the way i see it. please correct me if i'm wrong.
>>
>> both wl18xx and wl12xx use the platform data to get the irq number.
>> wl12xx (only) also needs some additional clock definitions to be
>> passed. there's currently some issue with specifying some the of clock
>> sources, so i preferred starting only with (the simpler) wl18xx
>> bindings.
>>
>> for platforms with wl18xx, we can remove the pdata-quirk, as all the
>> data (i.e. irq) can be passed by the new DT bindings.
>> however, for platforms with wl12xx, we still need to pass the clock
>> definitions (along with the irq), so we have to keep
>> legacy_init_wl12xx for the time being (and that's also why we have to
>> currently keep the platform_data handling in the wlcore driver)
>>
>> do you have something else in mind?
>
> I think what Arnd is saying is we've now removed all the wl12xx using
> legacy platforms, so all of them can boot with just data from dts.
>
I don't think that's the case (unless i'm missing something).
e.g. there's still pdata-quirk for "compulab,omap3-sbc-t3730" which
initializes wl12xx device.

Eliad.