[PATCH 08/15] ARM: shmobile: ape6evm dts: Fix polarity of LEDs

[Simon Horman]

From: Geert Uytterhoeven <geert+renesas at glider.be>

While the LEDs on r8a73a4/ape6evm are tied to VSUPPLY, they're driven by
an N-channel MOSFET. Hence the GPIO signal should be active high.

Signed-off-by: Geert Uytterhoeven <geert+renesas at glider.be>
Signed-off-by: Simon Horman <horms+renesas at verge.net.au>
---
 arch/arm/boot/dts/r8a73a4-ape6evm.dts | 12 ++++++------
 1 file changed, 6 insertions(+), 6 deletions(-)

diff --git a/arch/arm/boot/dts/r8a73a4-ape6evm.dts b/arch/arm/boot/dts/r8a73a4-ape6evm.dts
index 0d50bef..e8f3f38 100644
--- a/arch/arm/boot/dts/r8a73a4-ape6evm.dts
+++ b/arch/arm/boot/dts/r8a73a4-ape6evm.dts
@@ -95,27 +95,27 @@
 	leds {
 		compatible = "gpio-leds";
 		led1 {
-			gpios = <&pfc 28 GPIO_ACTIVE_LOW>;
+			gpios = <&pfc 28 GPIO_ACTIVE_HIGH>;
 			label = "GNSS_EN";
 		};
 		led2 {
-			gpios = <&pfc 126 GPIO_ACTIVE_LOW>;
+			gpios = <&pfc 126 GPIO_ACTIVE_HIGH>;
 			label = "NFC_NRST";
 		};
 		led3 {
-			gpios = <&pfc 132 GPIO_ACTIVE_LOW>;
+			gpios = <&pfc 132 GPIO_ACTIVE_HIGH>;
 			label = "GNSS_NRST";
 		};
 		led4 {
-			gpios = <&pfc 232 GPIO_ACTIVE_LOW>;
+			gpios = <&pfc 232 GPIO_ACTIVE_HIGH>;
 			label = "BT_WAKEUP";
 		};
 		led5 {
-			gpios = <&pfc 250 GPIO_ACTIVE_LOW>;
+			gpios = <&pfc 250 GPIO_ACTIVE_HIGH>;
 			label = "STROBE";
 		};
 		led6 {
-			gpios = <&pfc 288 GPIO_ACTIVE_LOW>;
+			gpios = <&pfc 288 GPIO_ACTIVE_HIGH>;
 			label = "BBRESETOUT";
 		};
 	};
-- 
2.1.4