[PATCH v2 3/6] mtd: nand: vf610_nfc: add device tree bindings

[Bill Pringlemeir]

On  9 Mar 2015, stefan at agner.ch wrote:

> Signed-off-by: Bill Pringlemeir <bpringlemeir at nbsps.com>
> Signed-off-by: Stefan Agner <stefan at agner.ch>
> ---
> .../devicetree/bindings/mtd/vf610-nfc.txt | 39 ++++++++++++++++++++++
> 1 file changed, 39 insertions(+) create mode 100644
> Documentation/devicetree/bindings/mtd/vf610-nfc.txt
>
> diff --git a/Documentation/devicetree/bindings/mtd/vf610-nfc.txt
> b/Documentation/devicetree/bindings/mtd/vf610-nfc.txt
> new file mode 100644
> index 0000000..312c872
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/mtd/vf610-nfc.txt

[snip]

> +- reg: Address range of the mtd chip 
> +- interrupts: Should contain the STMMAC interrupts 

What is 'STMMAC'?  Is that something I cribbed from another file?  Ah, I
see 'spear_smi.txt' which is an NAND driver with a 'clock-frequency'
parameter (probably before 'assigned-clocks' support).

 https://git.kernel.org/cgit/linux/kernel/git/torvalds/linux.git/tree/Documentation/devicetree/bindings/mtd/spear_smi.txt

I don't think 'STMMAC' makes sense.

  +- interrupts: irq to be used

Maybe?  Same as mxc-nand.txt.  It is not so helpful though.

> +- nand-bus-width: see nand.txt
> +- nand-ecc-mode: see nand.txt
> +- nand-on-flash-bbt: see nand.txt 
> +- clock-frequency : Optional clock rate to NFC in Hz

I guess this changed?  We might want to put a note about what kind of
impact this might have on the bus.  Ie,

 assigned-clocks: Input SOC clock to the NAND controller.
 assigned-clock-rates: The NAND bus timing is derived from this clock
    rate and should not exceed maximum timing for any NAND memory chip
    in a board stuffing.  Typical NAND memory timings derived from this
    clock are found in the SOC hardware reference manual.
 
Originally, the reason I made this file was because the
'clock-frequency' was non-standard.  I guess it is nice to have it
anyways.

Fwiw,
Bill Pringlemeir.