[PATCH v5 1/3] dt: bindings: add wl18xx wireless device

[Eliad Peller]

Add device tree binding documentation for TI's wl18xx
wlan chip.

Signed-off-by: Eliad Peller <eliad at wizery.com>
---
 .../devicetree/bindings/net/wireless/ti,wl18xx.txt | 39 ++++++++++++++++++++++
 1 file changed, 39 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/net/wireless/ti,wl18xx.txt

diff --git a/Documentation/devicetree/bindings/net/wireless/ti,wl18xx.txt b/Documentation/devicetree/bindings/net/wireless/ti,wl18xx.txt
new file mode 100644
index 0000000..9dcf535
--- /dev/null
+++ b/Documentation/devicetree/bindings/net/wireless/ti,wl18xx.txt
@@ -0,0 +1,39 @@
+TI Wilink8 (wl18xx) SDIO devices
+
+This node provides properties for controlling the wilink8 wireless device. The
+node is expected to be specified as a child node to the SDIO controller that
+connects the device to the system.
+
+Required properties:
+ - compatible : Should be "ti,wl18xx".
+ - compatible: should be one of the following:
+    * "ti,wl1801"
+    * "ti,wl1805"
+    * "ti,wl1807"
+    * "ti,wl1831"
+    * "ti,wl1835"
+    * "ti,wl1837"
+ - interrupts : specifies attributes for the out-of-band interrupt.
+
+Optional properties:
+ - interrupt-parent : the phandle for the interrupt controller to which the
+	device interrupts are connected.
+
+Example:
+
+&mmc3 {
+	status = "okay";
+	vmmc-supply = <&wlan_en_reg>;
+	bus-width = <4>;
+	cap-power-off-card;
+	keep-power-in-suspend;
+
+	#address-cells = <1>;
+	#size-cells = <0>;
+	wlcore: wlcore at 2 {
+		compatible = "ti,wl1835";
+		reg = <2>;
+		interrupt-parent = <&gpio0>;
+		interrupts = <19 IRQ_TYPE_NONE>;
+	};
+};
-- 
1.8.5.2.229.g4448466.dirty