[PATCH v3 5/9] mtd: pxa3xx_nand: add support for the Marvell Berlin nand controller
ezequiel.garcia at free-electrons.com
Mon Mar 9 04:37:51 PDT 2015
On 03/08/2015 07:19 PM, Robert Jarzmik wrote:
> Ezequiel Garcia <ezequiel.garcia at free-electrons.com> writes:
>>> I think you'll kill the zylonite board, and I'll nack it if that's the case. At
>>> least that's what happened when I tried to use onfi default values last time in
>>> barebox development.
>>> I can test your changes, but if the specific zylonite nand (ie. nand id 0xba20,
>>> ie. pxa310 embedded flash) gets broken, I'm against the removal of the legacy
>>> timings removal.
>> I'm not speaking of any timing params here, but about the flash
>> Which flash do you have there?
> The one with 0xba20 id as I said, which is AFAIK a Numonyx NAND02GR4B2C.
$ grep "0xBA" drivers/mtd/nand/nand_ids.c
EXTENDED_ID_NAND("NAND 256MiB 1,8V 16-bit", 0xBA, 256, LP_OPTIONS16),
Seems already supported by the NAND core. The MTD way of probing
a non-ONFI device is by using the IDs in nand_ids.c. Additional
configuration (timings in this case) is applied between the nand_scan_ident()
and nand_scan_tail() calls.
Ezequiel García, Free Electrons
Embedded Linux, Kernel and Android Engineering
More information about the linux-arm-kernel