[PATCH 0/3] ARM: sun9i: Add support for PRCM on Allwinner A80 SoC

[Chen-Yu Tsai]

Hi,

On Mon, Mar 9, 2015 at 1:32 AM, Maxime Ripard
<maxime.ripard at free-electrons.com> wrote:
> Hi Chen-Yu,
>
> On Tue, Mar 03, 2015 at 10:21:57AM +0800, Chen-Yu Tsai wrote:
>> Hi everyone,
>>
>> Some time ago I sent out an RFC series, which was not merged due
>> to lack of matching documentation for the SoC. A few weeks back I
>> sent out a request for the documents again. I have not received a
>> response. So I'm sending out the series now.
>>
>> This series adds support for the Power Reset and Clock Management
>> module on Allwinner's A80 SoC. The PRCM manages clocks and resets
>> for the "special" block of peripherals, or the R/RTC block in
>> earlier SoCs. These peripherals include a standby processor core,
>> a timer block, a watchdog, pin controller, 1 wire interface, PS/2
>> interface, a UART, the RSB controller, a DMA controller, a consumer
>> IR receiver block, 2 I2C controllers, and 2 I2S controllers. We do
>> not have documents for all the peripherals. Support will be added
>> where possible.
>>
>>
>> Patch 1 adds support for the apbs (apb0 in earlier SoCs) gates.
>>
>> Patch 2 adds sun9i-a80 support to the PRCM mfd driver
>>
>> Patch 3 adds the clock and reset nodes for the PRCM to the A80 DTSI.
>
> These three patches look fine to me. Have you seen that the new
> bootloader code has some interesting infos about RSB and PRCM?
>
> If so, does it match what you did so far?

It does. Though that's the only stuff I found on PRCM in there.
Previously I used u-boot and kernel sources from the SDK as a
source of information.

ChenYu

>> To Allwinner people:
>> If you have any related documents or comments, please send them out.
>
> Kevin, Shuge, your input would be greatly appreciated.
>
> Thanks!
> Maxime
>
> --
> Maxime Ripard, Free Electrons
> Embedded Linux, Kernel and Android engineering
> http://free-electrons.com