[PATCH 3/5] dt-bindings: mediatek: Add smi dts binding

[Sergei Shtylyov]

Hello.

On 3/6/2015 1:48 PM, yong.wu at mediatek.com wrote:

> From: Yong Wu <yong.wu at mediatek.com>

> This patch add smi binding document.

> Signed-off-by: Yong Wu <yong.wu at mediatek.com>
> ---
>   .../devicetree/bindings/soc/mediatek/mediatek,smi.txt   | 17 +++++++++++++++++
>   1 file changed, 17 insertions(+)
>   create mode 100644 Documentation/devicetree/bindings/soc/mediatek/mediatek,smi.txt

> diff --git a/Documentation/devicetree/bindings/soc/mediatek/mediatek,smi.txt b/Documentation/devicetree/bindings/soc/mediatek/mediatek,smi.txt
> new file mode 100644
> index 0000000..0fc9d1a
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/soc/mediatek/mediatek,smi.txt
> @@ -0,0 +1,17 @@
> +SMI hardware block diagram please help check <bindings/iommu/mediatek,iommu.txt>
> +
> +Required properties:
> +- compatible : must be "mediatek,mediatek,mt8173-smi-larb"

    One "mediatek," is enough. :-)

> +- reg : the register of each local arbiter
> +- clocks : the clocks of each local arbiter
> +- clock-name: larb_sub*(3 clockes at most)

    clock-names.

> +
> +Example:
> +	larb1:larb at 16010000 {
> +	        compatible = "mediatek,mt8173-smi-larb";
> +		reg = <0 0x16010000 0 0x1000>;
> +		clocks = <&mmsys MM_SMI_COMMON>,
> +		        <&vdecsys VDEC_CKEN>,

    Please align with the < above.

> +                        <&vdecsys VDEC_LARB_CKEN>;

    Use tabs instead of spaces, please.

> +		clock-names = "larb_sub0", "larb_sub1", "larb_sub2";
> +	};

WBR, Sergei