[linux-sunxi] Re: [PATCH] ARM: sun6i: dt: Add new Mele I7 device

[Hans de Goede]

Hi,

On 03-03-15 09:22, Maxime Ripard wrote:
> On Tue, Mar 03, 2015 at 08:55:36AM +0100, Hans de Goede wrote:
>>>> +/ {
>>>> +	model = "Mele I7 Quad top set box";
>>>> +	compatible = "mele,i7", "allwinner,sun6i-a31";
>>>> +
>>>> +	chosen {
>>>> +		bootargs = "earlyprintk console=ttyS0,115200";
>>>
>>> Using earlyprintk by default is a bad idea if the kernel is configured
>>> with DEBUG_LL support for another SoC.
>>
>> While on this subject, u-boot now sets the chosen/stdout-path property
>> up by default, which means that the kernel will do the right thing by
>> default. So we we really do not need any bootargs= in our dts files.
>
> I just tested that this weekend, and it turned out that the kernel
> couldn't use it so far (ie, no output until init takes over and setup
> a TTY on ttyS0).
>
> Was it working for you?

Yes, note that the kernel only honors the stdout-path property if
there is no console= argument present if there is a console= argument
present on the kernel cmdline then that will overrule the stdout-path
property.

Which board did you test with, and what u-boot and kernel version ?

>> Currently we've a random mix where we do have bootargs in some, but
>> not in most sunxi dts files. I believe we should simply remove it
>> everywhere...
>
> We used to set them in SoCs that are not supported by U-boot yet, and
> where the bootloader won't come and patch the DT (A31, A23, A80).

Ah, so that is (was) the logic, following that logic we should probably
remove bootargs= from at least the a23 and a31 boards (basically
from all boards but a80).

Regards,

Hans