[RFC 2/5] mtd:fsl_nfc: Add hardware 45 byte BHC-ECC support for 24 bit corrections.

[Bill Pringlemeir]

On 28 Feb 2015, stefan at agner.ch wrote:

> The flash chip mentioned above requires 8-bit error correction per 512
> byte block, hence I increased the ECC to the maximum available level
> (60-byte ECC, see page below). One thing which is not very nice, in
> order to fit the 60-byte ECC into the 64-byte OOB, I had to shorten
> the BBT pattern and set it at the very beginning of the page. This
> works fine, however this basically sets the page also to factory bad,
> I'm not sure if this is ok? Otherwise, we also could use a BBT pattern
> of length 1 (used by cafe_nand.c too).

I guess that is a DT option?  I wouldn't be an expert on this.  So
submitting it to the linux-mtd is good.  

I am also not sure if the HW ECC will work with 'sub-pages'.  I think a
college of your at Toradex submitted a patch to the u-boot.  I am pretty
sure that it could work with software ECC, but maybe disabling it is
easiest.

> What do you think? I would like to respin the NFC patch, with my
> U-Boot changes and this change included...

Please go ahead.  Markus M <marb at ixxat.de> is also using the fsl_nfc
driver on a Freescale MPC5125 board, so it is probably good to copy your
patches to him.  At least, he can test on a BE platform.

People also complained about JFFS and this version of the driver.  I
didn't investigate that.

Thanks,
Bill Pringlemeir.