[PATCH 4/7] pinctrl: sh-pfc: Stop calling gpiochip_add_pin_range() on DT platforms

Geert Uytterhoeven geert+renesas at glider.be
Tue Jun 30 00:45:24 PDT 2015


On platforms where the PFC/GPIO controller is instantiated from DT, the
mapping between GPIOs and pins is set up using the "gpio-ranges"
property in DT.

Hence stop setting up the mapping from C code on DT platforms.
This code is still used for SH or ARM-legacy platforms.

Signed-off-by: Geert Uytterhoeven <geert+renesas at glider.be>
---
 drivers/pinctrl/sh-pfc/gpio.c | 36 ++++++++++++++++++++----------------
 1 file changed, 20 insertions(+), 16 deletions(-)

diff --git a/drivers/pinctrl/sh-pfc/gpio.c b/drivers/pinctrl/sh-pfc/gpio.c
index ba353735ecf2be9a..1be118e4865fd3f8 100644
--- a/drivers/pinctrl/sh-pfc/gpio.c
+++ b/drivers/pinctrl/sh-pfc/gpio.c
@@ -379,22 +379,26 @@ int sh_pfc_register_gpiochip(struct sh_pfc *pfc)
 
 	pfc->gpio = chip;
 
-	/* Register the GPIO to pin mappings. As pins with GPIO ports must come
-	 * first in the ranges, skip the pins without GPIO ports by stopping at
-	 * the first range that contains such a pin.
-	 */
-	for (i = 0; i < pfc->nr_ranges; ++i) {
-		const struct sh_pfc_pin_range *range = &pfc->ranges[i];
-
-		if (range->start >= pfc->nr_gpio_pins)
-			break;
-
-		ret = gpiochip_add_pin_range(&chip->gpio_chip,
-					     dev_name(pfc->dev),
-					     range->start, range->start,
-					     range->end - range->start + 1);
-		if (ret < 0)
-			return ret;
+	if (IS_ENABLED(CONFIG_SUPERH) ||
+	    IS_ENABLED(CONFIG_ARCH_SHMOBILE_LEGACY)) {
+		/*
+		 * Register the GPIO to pin mappings. As pins with GPIO ports
+		 * must come first in the ranges, skip the pins without GPIO
+		 * ports by stopping at the first range that contains such a
+		 * pin.
+		 */
+		for (i = 0; i < pfc->nr_ranges; ++i) {
+			const struct sh_pfc_pin_range *range = &pfc->ranges[i];
+
+			if (range->start >= pfc->nr_gpio_pins)
+				break;
+
+			ret = gpiochip_add_pin_range(&chip->gpio_chip,
+				dev_name(pfc->dev), range->start, range->start,
+				range->end - range->start + 1);
+			if (ret < 0)
+				return ret;
+		}
 	}
 
 	/* Register the function GPIOs chip. */
-- 
1.9.1




More information about the linux-arm-kernel mailing list