[PATCH v2] arm: configs: Add Freescale LS1021A defconfig

Haikun Wang haikun.wang at freescale.com
Fri Jun 26 05:19:24 PDT 2015


Add Freescale LS1021A initial defconfig file.
The LS1021A SoC is a dual-core Cortex-A7 based processor.

LS1021A has some special configure options against common V7 SOCs,
such as CONFIG_THUMB2_KERNEL, CONFIG_VMSPLIT_2G, CONFIG_VFP...

Enable I2C, LPUART, eDMA, WDT default.
LS1021AQDS and LS1021ATWR boot successfully with patch.
Above IPs also been verified successfully.

Signed-off-by: Haikun Wang <haikun.wang at freescale.com>
---
 arch/arm/configs/ls1021a_defconfig | 140 +++++++++++++++++++++++++++++++++++++
 1 file changed, 140 insertions(+)
 create mode 100644 arch/arm/configs/ls1021a_defconfig

diff --git a/arch/arm/configs/ls1021a_defconfig b/arch/arm/configs/ls1021a_defconfig
new file mode 100644
index 0000000..3c893c8
--- /dev/null
+++ b/arch/arm/configs/ls1021a_defconfig
@@ -0,0 +1,140 @@
+CONFIG_SYSVIPC=y
+CONFIG_POSIX_MQUEUE=y
+CONFIG_NO_HZ_IDLE=y
+CONFIG_HIGH_RES_TIMERS=y
+CONFIG_LOG_BUF_SHIFT=16
+CONFIG_BLK_DEV_INITRD=y
+CONFIG_CC_OPTIMIZE_FOR_SIZE=y
+CONFIG_SYSCTL_SYSCALL=y
+CONFIG_KALLSYMS_ALL=y
+CONFIG_EMBEDDED=y
+CONFIG_PROFILING=y
+CONFIG_OPROFILE=y
+CONFIG_KPROBES=y
+CONFIG_JUMP_LABEL=y
+CONFIG_MODULES=y
+CONFIG_MODULE_FORCE_LOAD=y
+CONFIG_MODULE_UNLOAD=y
+CONFIG_BLK_CMDLINE_PARSER=y
+CONFIG_ARCH_MXC=y
+CONFIG_SOC_LS1021A=y
+CONFIG_ARM_LPAE=y
+CONFIG_SMP=y
+CONFIG_VMSPLIT_2G=y
+CONFIG_PREEMPT_VOLUNTARY=y
+CONFIG_THUMB2_KERNEL=y
+CONFIG_HIGHMEM=y
+CONFIG_CLEANCACHE=y
+CONFIG_FRONTSWAP=y
+CONFIG_CMDLINE="console=ttyS0,115200"
+CONFIG_VFP=y
+CONFIG_NEON=y
+CONFIG_KERNEL_MODE_NEON=y
+CONFIG_BINFMT_MISC=y
+CONFIG_NET=y
+CONFIG_PACKET=y
+CONFIG_UNIX=y
+CONFIG_UNIX_DIAG=y
+CONFIG_XFRM_USER=y
+CONFIG_NET_KEY=y
+CONFIG_INET=y
+CONFIG_IP_MULTICAST=y
+CONFIG_IP_ADVANCED_ROUTER=y
+CONFIG_IP_PNP=y
+CONFIG_IP_PNP_DHCP=y
+CONFIG_IP_MROUTE=y
+CONFIG_INET_AH=y
+CONFIG_INET_ESP=y
+CONFIG_INET_IPCOMP=y
+CONFIG_INET_UDP_DIAG=y
+CONFIG_NETFILTER=y
+CONFIG_DEVTMPFS=y
+CONFIG_DEVTMPFS_MOUNT=y
+CONFIG_MTD=y
+CONFIG_MTD_CMDLINE_PARTS=y
+CONFIG_MTD_BLOCK=y
+CONFIG_MTD_CFI=y
+CONFIG_MTD_CFI_ADV_OPTIONS=y
+CONFIG_MTD_CFI_BE_BYTE_SWAP=y
+CONFIG_MTD_CFI_GEOMETRY=y
+CONFIG_MTD_CFI_INTELEXT=y
+CONFIG_MTD_CFI_AMDSTD=y
+CONFIG_MTD_CFI_STAA=y
+CONFIG_MTD_PHYSMAP_OF=y
+CONFIG_MTD_SST25L=y
+CONFIG_MTD_NAND=y
+CONFIG_BLK_DEV_LOOP=y
+CONFIG_BLK_DEV_RAM=y
+CONFIG_BLK_DEV_RAM_SIZE=256000
+CONFIG_SRAM=y
+CONFIG_BLK_DEV_SD=y
+CONFIG_CHR_DEV_SG=y
+CONFIG_ATA=y
+CONFIG_NETDEVICES=y
+CONFIG_VITESSE_PHY=y
+CONFIG_BROADCOM_PHY=y
+CONFIG_REALTEK_PHY=y
+CONFIG_NATIONAL_PHY=y
+CONFIG_MICREL_PHY=y
+CONFIG_MDIO_BUS_MUX_MMIOREG=y
+CONFIG_INPUT_EVDEV=y
+CONFIG_SERIO_SERPORT=m
+CONFIG_SERIAL_8250=y
+CONFIG_SERIAL_8250_CONSOLE=y
+CONFIG_SERIAL_8250_EXTENDED=y
+CONFIG_SERIAL_8250_SHARE_IRQ=y
+CONFIG_SERIAL_OF_PLATFORM=y
+CONFIG_SERIAL_FSL_LPUART=y
+CONFIG_SERIAL_FSL_LPUART_CONSOLE=y
+CONFIG_HW_RANDOM=y
+CONFIG_I2C=y
+CONFIG_I2C_CHARDEV=y
+CONFIG_I2C_MUX=y
+CONFIG_I2C_MUX_PCA954x=y
+CONFIG_I2C_IMX=y
+CONFIG_GPIO_SYSFS=y
+CONFIG_SENSORS_LM90=y
+CONFIG_SENSORS_INA2XX=y
+CONFIG_WATCHDOG=y
+CONFIG_IMX2_WDT=y
+CONFIG_NEW_LEDS=y
+CONFIG_LEDS_CLASS=y
+CONFIG_LEDS_TRIGGERS=y
+CONFIG_RTC_CLASS=y
+CONFIG_RTC_DRV_DS3232=y
+CONFIG_DMADEVICES=y
+CONFIG_FSL_EDMA=y
+CONFIG_CLK_QORIQ=y
+CONFIG_MEMORY=y
+CONFIG_EXT2_FS=y
+CONFIG_EXT2_FS_XATTR=y
+CONFIG_EXT3_FS=y
+CONFIG_EXT4_FS=y
+CONFIG_FANOTIFY=y
+CONFIG_ISO9660_FS=m
+CONFIG_JOLIET=y
+CONFIG_ZISOFS=y
+CONFIG_UDF_FS=m
+CONFIG_MSDOS_FS=y
+CONFIG_VFAT_FS=y
+CONFIG_NTFS_FS=m
+CONFIG_TMPFS=y
+CONFIG_TMPFS_POSIX_ACL=y
+CONFIG_JFFS2_FS=y
+CONFIG_NFS_FS=y
+CONFIG_NFS_V4=y
+CONFIG_ROOT_NFS=y
+CONFIG_NLS_DEFAULT="cp437"
+CONFIG_NLS_CODEPAGE_437=y
+CONFIG_NLS_ASCII=y
+CONFIG_NLS_ISO8859_1=y
+CONFIG_NLS_ISO8859_2=y
+CONFIG_NLS_ISO8859_15=y
+CONFIG_NLS_UTF8=y
+CONFIG_DEBUG_SECTION_MISMATCH=y
+CONFIG_MAGIC_SYSRQ=y
+CONFIG_CRYPTO_LZO=y
+CONFIG_CRC_CCITT=m
+CONFIG_CRC_T10DIF=y
+CONFIG_CRC7=m
+CONFIG_LIBCRC32C=m
-- 
2.1.0.27.g96db324




More information about the linux-arm-kernel mailing list