[PATCH 07/17] usb: musb: omap2430: use *syscon* framework to write to mailbox register
Roger Quadros
rogerq at ti.com
Wed Jun 24 04:39:34 PDT 2015
On Tue, 23 Jun 2015 17:28:52 +0530
Kishon Vijay Abraham I <kishon at ti.com> wrote:
> Deprecate using phy-omap-control driver to write to the mailbox register
> and start using *syscon* framework to do the same.
>
> Signed-off-by: Kishon Vijay Abraham I <kishon at ti.com>
> ---
> Documentation/devicetree/bindings/usb/omap-usb.txt | 7 +-
> drivers/usb/musb/omap2430.c | 118 ++++++++++++++++----
> 2 files changed, 102 insertions(+), 23 deletions(-)
>
> diff --git a/Documentation/devicetree/bindings/usb/omap-usb.txt b/Documentation/devicetree/bindings/usb/omap-usb.txt
> index 38d9bb8..c001306 100644
> --- a/Documentation/devicetree/bindings/usb/omap-usb.txt
> +++ b/Documentation/devicetree/bindings/usb/omap-usb.txt
> @@ -20,10 +20,15 @@ OMAP MUSB GLUE
> - phy-names : the names of the PHY corresponding to the PHYs present in the
> *phy* phandle.
>
> -Optional properties:
> +Optional Properties:
> +Deprecated properties:
> - ctrl-module : phandle of the control module this glue uses to write to
> mailbox
>
> +Recommended properies:
> + - syscon-otghs : phandle/offset pair. Phandle to the system control module and the
> + register offset of the mailbox.
> +
> SOC specific device node entry
> usb_otg_hs: usb_otg_hs at 4a0ab000 {
> compatible = "ti,omap4-musb";
> diff --git a/drivers/usb/musb/omap2430.c b/drivers/usb/musb/omap2430.c
> index cc752d8..bcd6d1e 100644
> --- a/drivers/usb/musb/omap2430.c
> +++ b/drivers/usb/musb/omap2430.c
> @@ -39,16 +39,27 @@
> #include <linux/usb/musb-omap.h>
> #include <linux/phy/omap_control_phy.h>
> #include <linux/of_platform.h>
> +#include <linux/regmap.h>
> +#include <linux/mfd/syscon.h>
>
> #include "musb_core.h"
> #include "omap2430.h"
>
> +#define OMAP2430_MUSB_MODE_MASK 0x1f
> +#define OMAP2430_MUSB_AVALID (0x1 << 0)
> +#define OMAP2430_MUSB_BVALID (0x1 << 1)
> +#define OMAP2430_MUSB_VBUSVALID (0x1 << 2)
> +#define OMAP2430_MUSB_SESSEND (0x1 << 3)
> +#define OMAP2430_MUSB_IDDIG (0x1 << 4)
> +
> struct omap2430_glue {
> struct device *dev;
> struct platform_device *musb;
> enum omap_musb_vbus_id_status status;
> struct work_struct omap_musb_mailbox_work;
> struct device *control_otghs;
> + struct regmap *syscon_otghs; /* ctrl. reg. acces */
> + unsigned int otghs_reg; /* otghs reg. index within syscon */
> };
> #define glue_to_musb(g) platform_get_drvdata(g->musb)
>
> @@ -253,6 +264,47 @@ void omap_musb_mailbox(enum omap_musb_vbus_id_status status)
> }
> EXPORT_SYMBOL_GPL(omap_musb_mailbox);
>
> +static void omap2430_musb_set_usbmode(struct omap2430_glue *glue,
> + enum omap_control_usb_mode mode)
> +{
> + u32 val;
> + int ret;
> +
> + if (glue->syscon_otghs) {
> + switch (mode) {
> + case USB_MODE_HOST:
> + val = OMAP2430_MUSB_AVALID | OMAP2430_MUSB_VBUSVALID;
> + break;
> +
> + case USB_MODE_DEVICE:
> + val = OMAP2430_MUSB_IDDIG | OMAP2430_MUSB_AVALID |
> + OMAP2430_MUSB_VBUSVALID;
> + break;
> +
> + case USB_MODE_DISCONNECT:
> + val = OMAP2430_MUSB_IDDIG | OMAP2430_MUSB_SESSEND;
> + break;
> +
> + default:
> + dev_dbg(glue->dev, "Invalid mode\n");
> + goto err_regmap_update;
> + }
> +
> + ret = regmap_update_bits(glue->syscon_otghs,
> + glue->otghs_reg,
> + OMAP2430_MUSB_MODE_MASK, val);
> + if (ret < 0)
> + goto err_regmap_update;
> + } else {
> + omap_control_usb_set_mode(glue->control_otghs, mode);
> + }
> +
> + return;
> +
> +err_regmap_update:
> + dev_err(glue->dev, "Failed to set mode to %d\n", mode);
> +}
> +
> static void omap_musb_set_mailbox(struct omap2430_glue *glue)
> {
> struct musb *musb = glue_to_musb(glue);
> @@ -270,8 +322,7 @@ static void omap_musb_set_mailbox(struct omap2430_glue *glue)
> musb->xceiv->last_event = USB_EVENT_ID;
> if (musb->gadget_driver) {
> pm_runtime_get_sync(dev);
> - omap_control_usb_set_mode(glue->control_otghs,
> - USB_MODE_HOST);
> + omap2430_musb_set_usbmode(glue, USB_MODE_HOST);
> omap2430_musb_set_vbus(musb, 1);
> }
> break;
> @@ -284,7 +335,7 @@ static void omap_musb_set_mailbox(struct omap2430_glue *glue)
> musb->xceiv->last_event = USB_EVENT_VBUS;
> if (musb->gadget_driver)
> pm_runtime_get_sync(dev);
> - omap_control_usb_set_mode(glue->control_otghs, USB_MODE_DEVICE);
> + omap2430_musb_set_usbmode(glue, USB_MODE_DEVICE);
> break;
>
> case OMAP_MUSB_ID_FLOAT:
> @@ -301,8 +352,7 @@ static void omap_musb_set_mailbox(struct omap2430_glue *glue)
> if (data->interface_type == MUSB_INTERFACE_UTMI)
> otg_set_vbus(musb->xceiv->otg, 0);
>
> - omap_control_usb_set_mode(glue->control_otghs,
> - USB_MODE_DISCONNECT);
> + omap2430_musb_set_usbmode(glue, USB_MODE_DISCONNECT);
> break;
> default:
> dev_dbg(dev, "ID float\n");
> @@ -444,7 +494,7 @@ static void omap2430_musb_enable(struct musb *musb)
> switch (glue->status) {
>
> case OMAP_MUSB_ID_GROUND:
> - omap_control_usb_set_mode(glue->control_otghs, USB_MODE_HOST);
> + omap2430_musb_set_usbmode(glue, USB_MODE_HOST);
> if (data->interface_type != MUSB_INTERFACE_UTMI)
> break;
> devctl = musb_readb(musb->mregs, MUSB_DEVCTL);
> @@ -463,7 +513,7 @@ static void omap2430_musb_enable(struct musb *musb)
> break;
>
> case OMAP_MUSB_VBUS_VALID:
> - omap_control_usb_set_mode(glue->control_otghs, USB_MODE_DEVICE);
> + omap2430_musb_set_usbmode(glue, USB_MODE_DEVICE);
> break;
>
> default:
> @@ -477,8 +527,7 @@ static void omap2430_musb_disable(struct musb *musb)
> struct omap2430_glue *glue = dev_get_drvdata(dev->parent);
>
> if (glue->status != OMAP_MUSB_UNKNOWN)
> - omap_control_usb_set_mode(glue->control_otghs,
> - USB_MODE_DISCONNECT);
> + omap2430_musb_set_usbmode(glue, USB_MODE_DISCONNECT);
> }
>
> static int omap2430_musb_exit(struct musb *musb)
> @@ -507,6 +556,40 @@ static const struct musb_platform_ops omap2430_ops = {
>
> static u64 omap2430_dmamask = DMA_BIT_MASK(32);
>
> +static int omap2430_get_control(struct omap2430_glue *glue,
> + struct device_node *np)
> +{
> + struct device_node *control_node;
> + struct platform_device *control_pdev;
> +
> + glue->syscon_otghs = syscon_regmap_lookup_by_phandle(np,
> + "syscon-otghs");
> + if (IS_ERR(glue->syscon_otghs)) {
> + dev_info(glue->dev, "can't get syscon, using control device\n");
dev_dbg().
> + glue->syscon_otghs = NULL;
> +
> + control_node = of_parse_phandle(np, "ctrl-module", 0);
> + if (control_node) {
> + control_pdev = of_find_device_by_node(control_node);
> + if (!control_pdev) {
> + dev_err(glue->dev,
> + "Failed to get control device\n");
> + return -EINVAL;
> + }
> + glue->control_otghs = &control_pdev->dev;
> + }
> + } else {
> + if (of_property_read_u32_index(np, "syscon-otghs", 1,
> + &glue->otghs_reg)) {
> + dev_err(glue->dev,
> + "couldn't get otghs reg. offset\n");
> + return -EINVAL;
> + }
> + }
> +
> + return 0;
> +}
> +
> static int omap2430_probe(struct platform_device *pdev)
> {
> struct resource musb_resources[3];
> @@ -538,9 +621,6 @@ static int omap2430_probe(struct platform_device *pdev)
> glue->control_otghs = ERR_PTR(-ENODEV);
>
> if (np) {
> - struct device_node *control_node;
> - struct platform_device *control_pdev;
> -
> pdata = devm_kzalloc(&pdev->dev, sizeof(*pdata), GFP_KERNEL);
> if (!pdata)
> goto err2;
> @@ -567,16 +647,10 @@ static int omap2430_probe(struct platform_device *pdev)
> pdata->board_data = data;
> pdata->config = config;
>
> - control_node = of_parse_phandle(np, "ctrl-module", 0);
> - if (control_node) {
> - control_pdev = of_find_device_by_node(control_node);
> - if (!control_pdev) {
> - dev_err(&pdev->dev, "Failed to get control device\n");
> - ret = -EINVAL;
> - goto err2;
> - }
> - glue->control_otghs = &control_pdev->dev;
> - }
> + ret = omap2430_get_control(glue, np);
> + if (ret)
> + goto err2;
> +
> }
> pdata->platform_ops = &omap2430_ops;
>
cheers,
-roger
More information about the linux-arm-kernel
mailing list