[PATCH 01/17] phy: ti-pipe3: use ti_pipe3_power_off to power off the PHY during probe
Roger Quadros
rogerq at ti.com
Tue Jun 23 07:47:23 PDT 2015
On Tue, 23 Jun 2015 17:28:46 +0530
Kishon Vijay Abraham I <kishon at ti.com> wrote:
> No functional change. Previously omap_control_phy_power() was used to power
> off the PHY during probe. But once PIPE3 driver is adapted to use syscon,
> omap_control_phy_power() cannot be used. Hence used ti_pipe3_power_off
> to power off the PHY.
>
> Signed-off-by: Kishon Vijay Abraham I <kishon at ti.com>
Acked-by: Roger Quadros <rogerq at ti.com>
cheers,
-roger
> ---
> drivers/phy/phy-ti-pipe3.c | 4 ++--
> 1 file changed, 2 insertions(+), 2 deletions(-)
>
> diff --git a/drivers/phy/phy-ti-pipe3.c b/drivers/phy/phy-ti-pipe3.c
> index 08020dc..d784426 100644
> --- a/drivers/phy/phy-ti-pipe3.c
> +++ b/drivers/phy/phy-ti-pipe3.c
> @@ -431,8 +431,6 @@ static int ti_pipe3_probe(struct platform_device *pdev)
>
> phy->control_dev = &control_pdev->dev;
>
> - omap_control_phy_power(phy->control_dev, 0);
> -
> platform_set_drvdata(pdev, phy);
> pm_runtime_enable(phy->dev);
>
> @@ -451,6 +449,8 @@ static int ti_pipe3_probe(struct platform_device *pdev)
> return PTR_ERR(generic_phy);
>
> phy_set_drvdata(generic_phy, phy);
> + ti_pipe3_power_off(generic_phy);
> +
> phy_provider = devm_of_phy_provider_register(phy->dev,
> of_phy_simple_xlate);
> if (IS_ERR(phy_provider))
> --
> 1.7.9.5
>
More information about the linux-arm-kernel
mailing list