[PATCH v2 1/1] PCI: X-Gene: Disable Configuration Request Retry Status for X-Gene v1 PCIe
Tanmay Inamdar
tinamdar at apm.com
Thu Jun 18 11:00:22 PDT 2015
Hi,
On Fri, Jun 12, 2015 at 5:35 PM, Duc Dang <dhdang at apm.com> wrote:
> X-Gene v1 PCIe controller has a bug in Configuration Request Retry
> Status (CRS) logic:
> When CPU tries to read Vendor ID and Device ID of not-existed
> remote device, the controller returns 0xFFFF0001 instead of
> 0xFFFFFFFF; this will add significant delay in boot time as
> pci_bus_read_dev_vendor_id will wait for 60 seconds before
> giving up.
>
> So for X-Gene v1 PCIe controllers, disable CRS capability
> advertisement by clearing CRS Software Visibility bit before
> returning the Root Capability value to the callers. This is done
> by implementing X-Gene PCIe specific xgene_pcie_config_read32 for
> CFG read accesses to replace the generic default pci_generic_config_read32
> function.
>
> v2 changes:
> Use pci_generic_config_read32 to implement xgene_pcie_config_read32
>
> Signed-off-by: Duc Dang <dhdang at apm.com>
> Tested-by: Ian Campbell <ian.campbell at citrix.com>
> Tested-by: Marcin Juszkiewicz <mjuszkiewicz at redhat.com>
Acked-by: Tanmay Inamdar <tinamdar at apm.com
> ---
> drivers/pci/host/pci-xgene.c | 43 ++++++++++++++++++++++++++++++++++++++++++-
> 1 file changed, 42 insertions(+), 1 deletion(-)
>
> diff --git a/drivers/pci/host/pci-xgene.c b/drivers/pci/host/pci-xgene.c
> index e6c8864..7e3cf28 100644
> --- a/drivers/pci/host/pci-xgene.c
> +++ b/drivers/pci/host/pci-xgene.c
> @@ -59,6 +59,12 @@
> #define SZ_1T (SZ_1G*1024ULL)
> #define PIPE_PHY_RATE_RD(src) ((0xc000 & (u32)(src)) >> 0xe)
>
> +#define ROOT_CAP_AND_CTRL 0x5C
> +
> +/* PCIe IP version */
> +#define XGENE_PCIE_IP_VER_UNKN 0
> +#define XGENE_PCIE_IP_VER_1 1
> +
> struct xgene_pcie_port {
> struct device_node *node;
> struct device *dev;
> @@ -67,6 +73,7 @@ struct xgene_pcie_port {
> void __iomem *cfg_base;
> unsigned long cfg_addr;
> bool link_up;
> + u32 version;
> };
>
> static inline u32 pcie_bar_low_val(u32 addr, u32 flags)
> @@ -140,9 +147,39 @@ static void __iomem *xgene_pcie_map_bus(struct pci_bus *bus, unsigned int devfn,
> return xgene_pcie_get_cfg_base(bus) + offset;
> }
>
> +int xgene_pcie_config_read32(struct pci_bus *bus, unsigned int devfn,
> + int where, int size, u32 *val)
> +{
> + struct xgene_pcie_port *port = bus->sysdata;
> +
> + if (pci_generic_config_read32(bus, devfn, where & ~0x3, 4, val) !=
> + PCIBIOS_SUCCESSFUL)
> + return PCIBIOS_DEVICE_NOT_FOUND;
> + /*
> + * X-Gene v1 PCIe controller has a bug in Configuration Request
> + * Retry Status (CRS) logic:
> + * When CPU tries to read Vendor ID and Device ID of not-existed
> + * remote device, the controller returns 0xFFFF0001 instead of
> + * 0xFFFFFFFF; this will add significant delay in boot time as
> + * pci_bus_read_dev_vendor_id will wait for 60 seconds before
> + * giving up.
> + * So for X-Gene v1 PCIe controllers, disable CRS capability
> + * advertisement by clearing CRS Software Visibility bit before
> + * returning the Root Capability value to the callers.
> + */
> + if (pci_is_root_bus(bus) && (port->version == XGENE_PCIE_IP_VER_1) &&
> + ((where & ~0x3) == ROOT_CAP_AND_CTRL))
> + *val &= ~(PCI_EXP_RTCAP_CRSVIS << 16);
> +
> + if (size <= 2)
> + *val = (*val >> (8 * (where & 3))) & ((1 << (size * 8)) - 1);
> +
> + return PCIBIOS_SUCCESSFUL;
> +}
> +
> static struct pci_ops xgene_pcie_ops = {
> .map_bus = xgene_pcie_map_bus,
> - .read = pci_generic_config_read32,
> + .read = xgene_pcie_config_read32,
> .write = pci_generic_config_write32,
> };
>
> @@ -500,6 +537,10 @@ static int xgene_pcie_probe_bridge(struct platform_device *pdev)
> port->node = of_node_get(pdev->dev.of_node);
> port->dev = &pdev->dev;
>
> + port->version = XGENE_PCIE_IP_VER_UNKN;
> + if (of_device_is_compatible(port->node, "apm,xgene-pcie"))
> + port->version = XGENE_PCIE_IP_VER_1;
> +
> ret = xgene_pcie_map_reg(port, pdev);
> if (ret)
> return ret;
> --
> 1.9.1
>
More information about the linux-arm-kernel
mailing list