[PATCH v6 05/14] crypto: marvell/CESA: add TDMA support

[Boris Brezillon]

On Thu, 18 Jun 2015 10:48:03 +0100
Russell King - ARM Linux <linux at arm.linux.org.uk> wrote:

> On Thu, Jun 18, 2015 at 11:33:24AM +0200, Boris Brezillon wrote:
> > Hi Russel,
> > 
> > On Thu, 18 Jun 2015 10:04:00 +0100
> > Russell King - ARM Linux <linux at arm.linux.org.uk> wrote:
> > 
> > > On Wed, Jun 17, 2015 at 05:50:01PM +0800, Herbert Xu wrote:
> > > > On Wed, Jun 17, 2015 at 09:45:33AM +0200, Boris Brezillon wrote:
> > > > >
> > > > > +	ret = dma_map_sg(cesa_dev->dev, req->src, creq->src_nents,
> > > > > +			 DMA_TO_DEVICE);
> > > > > +	if (!ret)
> > > > > +		return -ENOMEM;
> > > > > +
> > > > > +	creq->src_nents = ret;
> > > > 
> > > > DMA-API-HOWTO says that you must retain the original nents and
> > > > use it when you call dma_unmap_sg.  So I'm afraid one more repost
> > > > is needed :)
> > > 
> > > It's worse than that...  You're right on that point, but there's an
> > > additional point.
> > > 
> > > If dma_map_sg() coalesces scatterlist entries, then ret will be smaller
> > > than src_nents, and ret indicates how many scatterlist entries to be
> > > walked during DMA - you should not use src_nents for that.  I couldn't
> > > see where the driver used that information.  In fact, the driver seems
> > > to be capable of walking more than src_nents/ret numbers of scatterlist
> > > entries: it just keeps going with sg_next() until it hits the end of
> > > the allocated scatterlist.
> > 
> > Yes, I realized that, and I never used the value returned by
> > dma_map_sg() to walk the scatterlist anyway: I was using the sg_next()
> > and sg->length value (which I replaced by sg_dma_len() in v7 as
> > suggested by Herbert).
> > So the ->src_nents assignment to dma_map_sg() return value was just a
> > silly mistake caused by an uncareful read of the DMA-API-HOWTO.
> > 
> > Am I missing something else ?
> 
> Yes.  'ret' should be used to indicate the number of scatterlist entries
> to walk for DMA purposes after the scatterlist has been mapped.  For PIO
> purposes, using src_nents is still acceptable.
> 
> As Herbert points out, you're stopping after the sum of transferred bytes
> matches, so I suppose that's fine.
> 
> One other point though: you should use sg_dma_address() rather than
> dereferencing sg->dma_address directly.
> 

Okay, I'll fix that before submitting a new version.

Thanks,

Boris



-- 
Boris Brezillon, Free Electrons
Embedded Linux and Kernel engineering
http://free-electrons.com