[BUG] at91: macb: does not work

Jiří Prchal jiri.prchal at aksignal.cz
Tue Jun 16 06:32:55 PDT 2015



On 16.6.2015 15:24, Boris Brezillon wrote:
> Hi Jiri,
>
> On Tue, 16 Jun 2015 15:10:51 +0200
> Jiří Prchal <jiri.prchal at aksignal.cz> wrote:
>
>> Hi,
>> in v4.1-rc8 does not work ethernet. It normally gets up, but no data are going through.
>>
>> [    4.400000] macb f802c000.ethernet (unnamed net_device) (uninitialized): invalid hw address, using random
>> [    4.510000] macb f802c000.ethernet eth0: Cadence MACB rev 0x0001010c at 0xf802c000 irq 37 (52:30:8f:6b:9c:b7)
>> [    4.520000] macb f802c000.ethernet eth0: attached PHY driver [Generic PHY] (mii_bus:phy_addr=f802c000.etherne:03, irq=-1)
>> [   15.510000] macb f802c000.ethernet eth0: link up (100/Full)
>>
>> / # ip -s link ls eth0
>> 2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast state UP mode DEFAULT group default qlen 1000
>>       link/ether a2:61:fe:17:65:b1 brd ff:ff:ff:ff:ff:ff
>>       RX: bytes  packets  errors  dropped overrun mcast
>>       0          0        0       0       0       0
>>       TX: bytes  packets  errors  dropped carrier collsns
>>       0          0        0       0       0       0
>>
>> In v4.0.5 it's working.
>
> On which platform are you testing (SoC and board) ?

Oh, sorry.
[    0.000000] AT91: Detected soc subtype: at91sam9g25
Board design like at91sam9x5ek.
Phy: DM9161BEP
Used RMII.

Jiri

>
> Best Regards,
>
> Boris
>
>>
>> I bisected it and found:
>> a848748959d554666b34cffc08ef2d23f4bb2990 is the first bad commit
>> commit a848748959d554666b34cffc08ef2d23f4bb2990
>> Author: Boris BREZILLON <boris.brezillon at free-electrons.com>
>> Date:   Sat Mar 7 07:23:30 2015 +0100
>>
>>       net: macb: remove #if defined(CONFIG_ARCH_AT91) sections
>>
>>       With multi platform support those sections could lead to unexpected
>>       behavior if both ARCH_AT91 and another ARM SoC using the MACB IP are
>>       selected.
>>       Add two new capabilities to encode the default MII mode and the presence
>>       of a CLKEN bit in USRIO register.
>>       Then define the appropriate config for IPs embedded in at91 SoCs.
>>
>>       Signed-off-by: Boris Brezillon <boris.brezillon at free-electrons.com>
>>       Reviewed-by: Alexandre Belloni <alexandre.belloni at free-electrons.com>
>>       Signed-off-by: David S. Miller <davem at davemloft.net>
>>
>> :040000 040000 1c87dbb47362b56e88a0e7256c991c64cf60e0bf af0bcc11f81aebf2c64afa5cd53766d494ea3fdb M	drivers
>>
>>
>> Jiri
>
>
>



More information about the linux-arm-kernel mailing list