[PATCH-V2 02/12] i2c: pxa: No need to set slave addr for i2c master mode reset
Vaibhav Hiremath
vaibhav.hiremath at linaro.org
Mon Jun 15 08:49:49 PDT 2015
Normally i2c controller works as master, so slave addr is not needed, or it
will impact some slave device (eg. ST NFC chip) i2c accesses, because it has
the same i2c address with controller.
Signed-off-by: Jett.Zhou <jtzhou at marvell.com>
Signed-off-by: Vaibhav Hiremath <vaibhav.hiremath at linaro.org>
Cc: Wolfram Sang <wsa at the-dreams.de>
---
drivers/i2c/busses/i2c-pxa.c | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/drivers/i2c/busses/i2c-pxa.c b/drivers/i2c/busses/i2c-pxa.c
index f4ac8c5..023e59f 100644
--- a/drivers/i2c/busses/i2c-pxa.c
+++ b/drivers/i2c/busses/i2c-pxa.c
@@ -459,7 +459,7 @@ static void i2c_pxa_reset(struct pxa_i2c *i2c)
writel(I2C_ISR_INIT, _ISR(i2c));
writel(readl(_ICR(i2c)) & ~ICR_UR, _ICR(i2c));
- if (i2c->reg_isar)
+ if (i2c->reg_isar && IS_ENABLED(CONFIG_I2C_PXA_SLAVE))
writel(i2c->slave_addr, _ISAR(i2c));
/* set control register values */
--
1.9.1
More information about the linux-arm-kernel
mailing list