[PATCH v2 5/6] regulator: Add input current limit support
Stephen Boyd
sboyd at codeaurora.org
Thu Jun 11 17:31:06 PDT 2015
Some regulators can limit their input current (typically annotated
as ilim). Add an op (set_input_current_limit) and a DT property +
constraint to support this.
Cc: <devicetree at vger.kernel.org>
Signed-off-by: Stephen Boyd <sboyd at codeaurora.org>
---
Documentation/devicetree/bindings/regulator/regulator.txt | 1 +
drivers/regulator/core.c | 9 +++++++++
drivers/regulator/of_regulator.c | 4 ++++
include/linux/regulator/driver.h | 3 +++
include/linux/regulator/machine.h | 2 ++
5 files changed, 19 insertions(+)
diff --git a/Documentation/devicetree/bindings/regulator/regulator.txt b/Documentation/devicetree/bindings/regulator/regulator.txt
index 4b1df61ccbd7..e29db73e55f4 100644
--- a/Documentation/devicetree/bindings/regulator/regulator.txt
+++ b/Documentation/devicetree/bindings/regulator/regulator.txt
@@ -7,6 +7,7 @@ Optional properties:
- regulator-microvolt-offset: Offset applied to voltages to compensate for voltage drops
- regulator-min-microamp: smallest current consumers may set
- regulator-max-microamp: largest current consumers may set
+- regulator-input-current-limit-microamp: maximum input current regulator allows
- regulator-always-on: boolean, regulator should never be disabled
- regulator-boot-on: bootloader/firmware enabled regulator
- regulator-allow-bypass: allow the regulator to go into bypass mode
diff --git a/drivers/regulator/core.c b/drivers/regulator/core.c
index 88622fc76b81..46c253e85c9e 100644
--- a/drivers/regulator/core.c
+++ b/drivers/regulator/core.c
@@ -1008,6 +1008,15 @@ static int set_machine_constraints(struct regulator_dev *rdev,
if (ret != 0)
goto out;
+ if (rdev->constraints->ilim_uA && ops->set_input_current_limit) {
+ ret = ops->set_input_current_limit(rdev,
+ rdev->constraints->ilim_uA);
+ if (ret < 0) {
+ rdev_err(rdev, "failed to set input limit\n");
+ goto out;
+ }
+ }
+
/* do we need to setup our suspend state */
if (rdev->constraints->initial_state) {
ret = suspend_prepare(rdev, rdev->constraints->initial_state);
diff --git a/drivers/regulator/of_regulator.c b/drivers/regulator/of_regulator.c
index 72576dd9bf7b..b41d80acbc4a 100644
--- a/drivers/regulator/of_regulator.c
+++ b/drivers/regulator/of_regulator.c
@@ -58,6 +58,10 @@ static void of_get_regulation_constraints(struct device_node *np,
if (!of_property_read_u32(np, "regulator-max-microamp", &pval))
constraints->max_uA = pval;
+ if (!of_property_read_u32(np, "regulator-input-current-limit-microamp",
+ &pval))
+ constraints->ilim_uA = pval;
+
/* Current change possible? */
if (constraints->min_uA != constraints->max_uA)
constraints->valid_ops_mask |= REGULATOR_CHANGE_CURRENT;
diff --git a/include/linux/regulator/driver.h b/include/linux/regulator/driver.h
index 02e1e8d4b1bb..1de82b081f5a 100644
--- a/include/linux/regulator/driver.h
+++ b/include/linux/regulator/driver.h
@@ -91,6 +91,7 @@ struct regulator_linear_range {
* @set_current_limit: Configure a limit for a current-limited regulator.
* The driver should select the current closest to max_uA.
* @get_current_limit: Get the configured limit for a current-limited regulator.
+ * @set_input_current_limit: Configure an input limit.
*
* @set_mode: Set the configured operating mode for the regulator.
* @get_mode: Get the configured operating mode for the regulator.
@@ -145,6 +146,8 @@ struct regulator_ops {
int min_uA, int max_uA);
int (*get_current_limit) (struct regulator_dev *);
+ int (*set_input_current_limit) (struct regulator_dev *, int lim_uA);
+
/* enable/disable regulator */
int (*enable) (struct regulator_dev *);
int (*disable) (struct regulator_dev *);
diff --git a/include/linux/regulator/machine.h b/include/linux/regulator/machine.h
index 7f7d0a3fe1e1..85a3b457de51 100644
--- a/include/linux/regulator/machine.h
+++ b/include/linux/regulator/machine.h
@@ -75,6 +75,7 @@ struct regulator_state {
*
* @min_uA: Smallest current consumers may set.
* @max_uA: Largest current consumers may set.
+ * @ilim_uA: Maximum input current.
* @system_load: Load that isn't captured by any consumer requests.
*
* @valid_modes_mask: Mask of modes which may be configured by consumers.
@@ -113,6 +114,7 @@ struct regulation_constraints {
/* current output range (inclusive) - for current control */
int min_uA;
int max_uA;
+ int ilim_uA;
int system_load;
--
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,
a Linux Foundation Collaborative Project
More information about the linux-arm-kernel
mailing list