[PATCH v1] ARM: zynq: Fix earlyprintk in big endian mode

Arun Chandran achandran at mvista.com
Wed Jun 10 07:13:04 PDT 2015


earlyprintk messages are not appearing on the terminal
emulator during a big endian kernel boot. If we
byte swap the sending data it comes properly.

Signed-off-by: Arun Chandran <achandran at mvista.com>
---
---
This can be tested by adding 'early_print("early print test\n");'
to setup_arch() in arch/arm/kernel/setup.c
---
 arch/arm/include/debug/zynq.S | 1 +
 1 file changed, 1 insertion(+)

diff --git a/arch/arm/include/debug/zynq.S b/arch/arm/include/debug/zynq.S
index bd13ded..0d274fe 100644
--- a/arch/arm/include/debug/zynq.S
+++ b/arch/arm/include/debug/zynq.S
@@ -38,6 +38,7 @@
 		.endm
 
 		.macro	senduart,rd,rx
+ARM_BE8(	rev	\rd, \rd )
 		str	\rd, [\rx, #UART_FIFO_OFFSET]	@ TXDATA
 		.endm
 
-- 
1.9.1




More information about the linux-arm-kernel mailing list