[PATCH v5 1/7] mmc: dt-bindings: add Mediatek MMC bindings

Ulf Hansson ulf.hansson at linaro.org
Wed Jun 10 05:02:29 PDT 2015


On 10 June 2015 at 04:24, Chaotian Jing <chaotian.jing at mediatek.com> wrote:
> Document the device-tree binding of Mediatek MMC host
>
> Signed-off-by: Chaotian Jing <chaotian.jing at mediatek.com>
> ---
>  Documentation/devicetree/bindings/mmc/mtk-sd.txt | 32 ++++++++++++++++++++++++
>  1 file changed, 32 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/mmc/mtk-sd.txt
>
> diff --git a/Documentation/devicetree/bindings/mmc/mtk-sd.txt b/Documentation/devicetree/bindings/mmc/mtk-sd.txt
> new file mode 100644
> index 0000000..a1adfa4
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/mmc/mtk-sd.txt
> @@ -0,0 +1,32 @@
> +* MTK MMC controller
> +
> +The MTK  MSDC can act as a MMC controller
> +to support MMC, SD, and SDIO types of memory cards.
> +
> +This file documents differences between the core properties in mmc.txt
> +and the properties used by the msdc driver.
> +
> +Required properties:
> +- compatible: Should be "mediatek,mt8173-mmc","mediatek,mt8135-mmc"
> +- interrupts: Should contain MSDC interrupt number
> +- clocks: MSDC source clock, HCLK
> +- clock-names: "source", "hclk"

According to the mmc driver, hclk is treated as an optional clock.
Therefore I think you should list it under an "Optional properties"
section instead.

> +- pinctrl-names: should be "default", "state_uhs"
> +- pinctrl-0: should contain default/high speed pin ctrl
> +- pinctrl-1: should contain uhs mode pin ctrl
> +- vmmc-supply: power to the Core
> +- vqmmc-supply: power to the IO
> +
> +Examples:
> +mmc0: mmc at 11230000 {
> +       compatible = "mediatek,mt8173-mmc", "mediatek,mt8135-mmc";
> +       reg = <0 0x11230000 0 0x108>;
> +       interrupts = <GIC_SPI 39 IRQ_TYPE_LEVEL_LOW>;
> +       vmmc-supply = <&mt6397_vemc_3v3_reg>;
> +       vqmmc-supply = <&mt6397_vio18_reg>;
> +       clocks = <&pericfg CLK_PERI_MSDC30_0>, <&topckgen CLK_TOP_MSDC50_0_H_SEL>;
> +       clock-names = "source", "hclk";
> +       pinctrl-names = "default", "state_uhs";
> +       pinctrl-0 = <&mmc0_pins_default>;
> +       pinctrl-1 = <&mmc0_pins_uhs>;
> +};
> --
> 1.8.1.1.dirty
>

Kind regards
Uffe



More information about the linux-arm-kernel mailing list