[LINUX RFC V2 1/2] devicetree: Add DT bindings documentation for Zynq Ultrascale+ MPSoC GQSPI controller

Sören Brinkmann soren.brinkmann at xilinx.com
Fri Jun 5 09:00:17 PDT 2015


On Fri, 2015-06-05 at 06:37PM +0530, Ranjit Waghmode wrote:
> Add bindings documentation for GQSPI controller driver used by
> Zynq Ultrascale+ MPSoC
> 
> Signed-off-by: Ranjit Waghmode <ranjit.waghmode at xilinx.com>
> ---
> No changes in v2
> ---
>  .../devicetree/bindings/spi/spi-zynqmp-qspi.txt    | 26 ++++++++++++++++++++++
>  1 file changed, 26 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/spi/spi-zynqmp-qspi.txt
> 
> diff --git a/Documentation/devicetree/bindings/spi/spi-zynqmp-qspi.txt b/Documentation/devicetree/bindings/spi/spi-zynqmp-qspi.txt
> new file mode 100644
> index 0000000..cec6330
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/spi/spi-zynqmp-qspi.txt
> @@ -0,0 +1,26 @@
> +Xilinx Zynq UltraScale+ MPSoC GQSPI controller Device Tree Bindings
> +-------------------------------------------------------------------
> +
> +Required properties:
> +- compatible		: Should be "xlnx,zynqmp-qspi-1.0".
> +- reg			: Physical base address and size of GQSPI registers map.
> +- interrupts		: Property with a value describing the interrupt
> +			  number.
> +- interrupt-parent	: Must be core interrupt controller.
> +- clock-names		: List of input clock names - "ref_clk", "pclk"
> +			  (See clock bindings for details).
> +- clocks		: Clock phandles (see clock bindings for details).
> +
> +Optional properties:
> +- num-cs		: Number of chip selects used.
> +
> +Example:
> +	qspi: spi at ff0f0000 {
> +		compatible = "xlnx,zynqmp-qspi-1.0";
> +		clock-names = "ref_clk", "pclk";
> +		clocks = <&misc_clk &misc_clk>;
> +		interrupts = <0 15 4>;
> +		interrupt-parent = <&gic>;
> +		num-cs = <1>;
> +		reg = <0x0 0xff0f0000 0x1000 0x0 0xc0000000 0x8000000>;

Please make this
  reg = <0x0 0xff0f0000 0x1000>, <0x0 0xc0000000 0x8000000>;

  	Sören



More information about the linux-arm-kernel mailing list