[ehci-orion] ETIMEOUT with ehci_setup()'s ehci_halt()
Valentin Longchamp
valentin.longchamp at keymile.com
Fri Jun 5 07:34:54 PDT 2015
Hello,
I am currently bringing up the USB 2.0 Host controller of the Bobcat's (98DX4122
Marvell switch) internal kirkwood CPU on a variation of Keymile's km_kirwood
hardware (kirkwood-km_kirkwood.dts).
When the driver registers its hcd, it fails with a timemout as it can be seen in
the below log:
> root at kmcoge5un:~# dmesg -n 8
> root at kmcoge5un:~# insmod ehci-orion.ko
> ehci-orion: EHCI orion driver
> Initializing Orion-SoC USB Host Controller
> orion-ehci f1050000.ehci: EHCI Host Controller
> orion-ehci f1050000.ehci: new USB bus registered, assigned bus number 1
> orion-ehci f1050000.ehci: reset hcs_params 0x10011 dbg=0 ind cc=0 pcc=0 ordered ports=1
> orion-ehci f1050000.ehci: reset hcc_params 0006 thresh 0 uframes 256/512/1024 park
> orion-ehci f1050000.ehci: park 0
> orion-ehci f1050000.ehci: reset command 0080002 (park)=0 ithresh=8 period=1024 Reset HALT
> orion-ehci f1050000.ehci: can't setup
> orion-ehci f1050000.ehci: USB bus 1 deregistered
> orion-ehci f1050000.ehci: init f1050000.ehci fail, -110
> orion-ehci: probe of f1050000.ehci failed with error -110
This is very similar to this problem, except that it always happens:
https://lkml.org/lkml/2012/6/4/381
I have cornered it out to the last handshake() call of the ehci_halt() call,
that should set the controller in the HALT state. If I comment this handshake()
call out, the registration is fine and the controller then looks OK (I don't
have a hardware with a real USB bus to further test it yet).
My current idea is that maybe a reset or an initialization may be missing, but I
wanted to ask if anybody already has seen a similar behavior with the various
hardware platform supported by ehci-orion ?
Best regards
Valentin
More information about the linux-arm-kernel
mailing list