[linux-sunxi] Re: [PATCH] ARM: dts: sun6i: Add a dts file for the Mele A1000G quad top set box

[Hans de Goede]

Hi,

On 02-06-15 23:49, Maxime Ripard wrote:
> On Tue, Jun 02, 2015 at 08:32:59PM +0200, Hans de Goede wrote:
>> Hi,
>>
>> On 06/02/2015 05:58 PM, Maxime Ripard wrote:
>>> On Mon, Jun 01, 2015 at 05:02:59PM +0200, Hans de Goede wrote:
>>>> The Mele A1000G-quad and the Mele M9 have the same PCB, sofar we've been using
>>>> the same dts for both models. Unfortunately this does not work for the otg
>>>> controller, on the M9 this is routed to a micro-usb connector on the outside,
>>>> while as on the A1000G-quad it is connected to an usb to sata bridge
>>>> (which is not populated on the M9 pcb).
>>>>
>>>> This commit adds a new dts for the Mele-A1000G-quad to allow using
>>>> different otg controller settings on the 2 boards.
>>>>
>>>> Signed-off-by: Hans de Goede <hdegoede at redhat.com>
>>>> ---
>>>>   arch/arm/boot/dts/Makefile                                        | 1 +
>>>>   arch/arm/boot/dts/{sun6i-a31-m9.dts => sun6i-a31-a1000g-quad.dts} | 4 ++--
>>>
>>> Didn't we say that we were trying to set the vendor name in the DTs
>>> now, at least for the new ones?
>>
>> I think we said that Paul would write a proposal to standardize
>> naming for future boards, but that never materialized.
>>
>>> I can fix this and apply it if it's ok for you.
>>
>> I'm fine with throwing -mele- in there, or not, what ever you
>> prefer.
>
> Ok, applied and fixed the name.
>
> This is probably going to be the last patch pulled for 4.2, unless
> something important shows up in the next few days.

That is fine with me, the only thing which I've pending on the dts
side is a hole lot of musb related patches which belong in 4.3 anyways.

What about the "ARM: dts: sun8i: Add Ippo-q8h v1.2 with A33 and 1024x600 lcd support"
commit? You had a remark on doing that differently to which I replied,
so that one is still in limbo a bit...

Regards,

Hans